2. UPLIFT Desk
  3. - 3D Fan Acoustic Wall Panel (Light Gray, Large)

UPLIFT Desk - 3D Fan Acoustic Wall Panel (Light Gray, Large) User guide

  • Hello! I am an AI chatbot trained to assist you with the UPLIFT Desk - 3D Fan Acoustic Wall Panel (Light Gray, Large) User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
®
3D Fan Acoustic Wall Panel
ACU008-LRG
AI-ACU008-0.0
Before you begin:
This product is attached to your wall, so you should plan accordingly. Know what sort of wall in which
you will be drilling and screwing. You may need to get additional parts such as plastic wall anchors.
3D Fan panel
Package Contents
Step 1
Determine the placement for the 3D Fan Acoustic Wall Panel on
your wall and make sure you have the wall space. Measure for
the fan, which is 35.5’’ in diameter.
Make a pencil mark on the wall where the hole is located.
Step 2
For most walls, drilling a pilot hole will make for a smooth
assembly.
Again, only you k
now what kind of wall you have. You may need
plastic wall anchor (not included), or you might just need to drill
directly into the wall. Use a 1/8’’ drill bit and drill your pilot hole.
Step 3
Hold the Fan up to the hole, or have a friend hold it in place for
you.
Place the Nylon washer inside the Threaded washer, then insert
the screw through both of them, then screw the three peices
through the hole in the Fan and into the wall.
Layering additional fans
If you purchased multiple fans and want an overlapping layered
effect, measure where you’d like the additional fans to be and
mark where the center of the next fan will be.
You will need additional items which are not provided in this kit,
including a standoff and a longer screw. The standoff should be
a drill-able material (such as a wood block or hard foam material)
and be at least 1” thick or thicker as per your desired installation.
You will need a new screw similar to the one provided but which
is long enough to properly accommodate your standoff.
Then just follow the above instructions, ensuring the standoff is
included between the fan and the wall.
1’’
+1’’
Step 4
Twist the Screw cap on over the Threaded washer.
UPLIFT Desk • 800-349-3839 • [email protected] • www.upliftdesk.com
M4x20 screw
Threaded washer
Nylon washer Screw cap
Copyright Notice: This guide is a component of this accessory. This guide is a part of the scope of delivery, even if the item is resold. This guide is also available on the UPLIFT Desk website: upliftdesk.com. Excerpts or copies may
not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
©
/