George Kovacs GKST1000-084 User manual

Step 1. Line up the drywall Step2. Finish the installation

Step3. Secure a threaded washer

Step 4.Screw the standoff Step 5. Remove the Standoff cap.

anchors with the marks on the using a screw driver to screw to the flushed anchor by driving

assembly to the threaded washer.

Slide the Rail into the Standoff.

ceiling and use a hammer to tap the anchor until is flush to the a screw into the anchor . While supporting the Rail, screw

the anchor approximately 1/2" ceiling. the Standoff Cap back onto the

into the ceiling.Stop just before Standoff.

the threaded portion of threaded

portion of the anchor enters the

ceiling

Installing or adjusting Standoff GKST1000/GKST1001

The standoff uses the quick adapter to attach to the rail.and adjust the standoff for you want Follow the step -by-step instructions below

LA-1302E

Threaded washer

Standoff

Threaded washer

This manual is also suitable for

Download PDF