APEC Water Systems HW-10 User manual

Brand
APEC Water Systems
Model
HW-10
Type
User manual
©2017 APEC Water Systems. All rights reserved. v.2017.1 www.freedrinkingwater.com
Remove plastic/paper wrappings on the 3 filters, put them into the 3 housings, and assemble the
housings onto the main system as follow:
1. See Fig. 1 Stand the 3 housings upright. Make sure each housing has a rubber O-ring in its
groove.
Put the APEC Sediment filter into the “1
st
stage” housing on the right.
Put the APEC Carbon filter into the “2
nd
stage” housing in the middle.
Put the APEC Carbon filter into the “3
rd
stage” housing on the left.
2. See Fig. 2 Starting from the 3
rd
stage housing on the left, hand twist the housing onto the main
system turning counterclockwise, one by one, for all 3 housings.
3. See Fig. 3 Use the wrench provided to completely tighten the housing starting from 1st-stage.
Repeat this step for the 2
nd
stage housing in the middle, and for the 3
rd
stage housing
on left.
Note: For some people it is easier to use the wrench with the system laid down
(face up).
Fig. 1
Fig. 2
Fig. 3
turn counter-clock
wise
to tighten
3rd
Stage
3rd
Stage
2nd
Stage
1st
Stage
Use
Wr
ench
Use
Assemble The Filters and Housings Onto The System
  • Page 1 1

APEC Water Systems HW-10 User manual

Brand
APEC Water Systems
Model
HW-10
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents