Page is loading ...
1 1
USER MANUAL
INVADER
PORTABLE
SPEAKER
kitsound.co.uk
JB.2576 / Made in China. © KitSound™ 2013
Christchurch, Dorset. BH23 4FL
2 3
We are craftspeople.
We are musicians.
We are KitSound
™
And we all commit ourselves
to achieving one shared goal:
Bringing people closer to their music.
By truly understanding music
we stay true to its craft.
Pure, rich, incredible sound.
We’ll settle for nothing less.
4 5
At KS we believe your music deserves to be
showcased on great quality products that don’t
cost the earth. We might not all share the same
taste in music (the ferocious disputes on music
forums prove that), but whether it’s Irish folk,
death metal or any number of obscure genres
which seem to be multiplying by the minute,
the artists responsible for connecting with you
through their craft have bared their souls to do so.
And we think that’s worth celebrating.
6 7
PLEASE READ THIS MANUAL CAREFULLY
BEFORE OPERATING THE SPEAKER SYSTEM.
Box Contents
• KS Invader portable speaker
• USB charge cable
• User manual
Power switch
Volume + Volume –
Face of the speaker
USB charge/audio
input/power light
3.5 mm audio
input/output plug
3.5 mm audio
input/output
Underneath the speaker
8 9
Charging the battery
1. USB charge/audio input
2. 3.5 mm jack plug
3. Standard USB connector
Opening the resonator
1. Hold the speaker firmly by the base
2. Turn the top cap anticlockwise by 5 mm
3. Let go of the cap to expand the resonator
Closing the resonator
1. Hold the speaker firmly by the base and press the
top cap down
2. Turn the top cap clockwise by 5 mm
1
2
3
Connect the USB charge cable (1) to the Invader
and connect the USB end (3) to a computer. A red
light on the Invader will indicate that it is charging.
After approximately two hours the light will turn
blue to indicate that it is fully charged.
Warning: This cable is not compatible for data
connectivity with other devices. It is intended
for this product only.
10 11
Specifications
• S/N: 80 dB
• Play time: up to 6 hours
• Driver size: 42 mm
• Frequency response: 80 Hz – 15 kHz
• Output: 3 W @ 4 ohm
Using the Invader
Connect the Invader to your device via the 3.5 mm
jack plug. You can also connect multiple speakers
together for increased impact:
1. Connect one of the Invaders to your device
via the 3.5 mm jack plug
2. Then connect an additional speaker to the
output audio socket of the first speaker
3. Repeat step 2 until all Invaders are connected
to each other
Caution: Do not pull the extendable resonator
forcibly as this may cause damage to the unit.
/
