2. Carmanah
  3. MX 200
MX 200

Carmanah MX 200 Installation guide

  • Hello! I've reviewed the MX 200 Solar Panel Replacement Guide and am ready to assist you. This document provides step-by-step instructions and diagrams for removing and replacing the solar panel on your device, including details on how to secure the new panel and check voltage using the MX Field app. If you have questions about the process, just ask!
  • How many screws need to be removed to detach solar panel from MX 200 chassis?
    What is the first step when starting to detach solar panel?
    What should be checked after the solar panel is replaced?
MX Series
MX 200 SOLAR PANEL REPLACEMENT GUIDE
LEVEL 4
1
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | [email protected] | carmanah.com
1. Unlock MX 200 and slide off lock bar.
2. Remove four screws securing solar panel to MX 200 chassis.
3. Disconnect solar panel connector and remove solar panel assembly.
90830REVA
2
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | [email protected] | carmanah.com
MX 200 SOLAR PANEL REPLACEMENT GUIDE
LEVEL 4
4. Remove four solar panel lid screws.
5. Squeeze grommet snap features and push grommet and cable end through hole.
3
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | [email protected] | carmanah.com
MX 200 SOLAR PANEL REPLACEMENT GUIDE
LEVEL 4
6. Place lid onto replacement solar panel in orientation shown and insert solar harness barrel
connector through hole in lid.
7. Push grommet into lid hole ensuring it is fully snapped in place.
8. Fasten lid to solar panel with four screws.
Check MX Field App to ensure solar panel is producing suitable voltage.
4
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | [email protected] | carmanah.com
MX 200 SOLAR PANEL REPLACEMENT GUIDE
LEVEL 4
9. Align hook features on lid with tabs on chassis. Mate solar harness connectors.
Lower solar panel assembly onto chassis and fasten with four screws.
10. Slide tab of lock bar into slot in lid.
11. Align shackle holes and lock MX 200.
/