Page is loading ...
English - 1
WARNING
Always disconnect power before removing covers.
Failure to do so may result in personal injury.
Step 1: Insert seat tabs into mounting slots on chair
frame and push downward on foot end. Rotate
locking knob on seat bottom to secure.
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
DA2454-1i
Seat
Headrest
Locking
Knob
Friction Cam
Adjustment Bolt
Seat Tab
003-2172-99 Rev. B (3/28/12)
Elevance Upholstery Installation Guide
Step 2: Insert headrest into mounting slot.
Applies to Models:
153810 (all)
Special Tools: none
Language of origin: English
Equipment Alert
Use the friction cam adjustment mechanism to set
the amount of tension necessary to raise/lower the
headrest. Once this adjustment is set, the mechanism maintains
that amount of tension.
Loosen
Step 3: Adjust headrest tension if necessary.
Loosen two hex screws and turn the friction
cam adjustment bolt to exert the desired amount
of tension on the headrest.
Tighten two hex screws to set the mechanism.
midmark.com
Style A
English - 2
© 2011 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
DA2458-1i
Back
Upholstery
Storage
Pocket
Back
Back
Mounting
Post
Chair Arm
Screw
Chair Back
Harnesses
Step 5: Connect harnesses in chair back to back
upholstery.
Step 4: Chairs without SerenEscape heat and massage option can go to Step 7.
Cut wire ties securing harnesses and gently pull out of storage cavities to make connections.
Step 6: Wire tie harnesses together and
gently push any excess into back
upholstery storage pocket.
Step 7: Align holes in back upholstery with back mounting
posts and push downward to lock in place. Insert
two screws thru chair arms and tighten to secure.
midmark.com
/