1
Instruction
Danfoss Heating VICSB202 Heating Solutions
Installation of additional insulation EPS / XPS
for SpeedUp
1 2
The substrate must be dry, level and load bearing (roughness tolerance
max. 3 mm/m).
Attach SpeedUp perimeter insulation on the wall. Avoid overlapping the
ends.
Note! Additional insulation ≥ 5 cm is laid without perimeter insulation but
position the perimeter insulation afterwards on the additional insulation.
3 4
Lightly score corners of perimeter insulation 3 cm from below, inside
corners from the wall and outside corners from room side.
Remove lap joints from the first insulation panels to achieve full coverage
up to wall.
5 6
Lay insulation panels in a staggered pattern and cross-laid to the eventual
direction of the SpeedUp heat panels.
When cutting to fit the next panel ensure that the lap joints always.
Only use whole panels through thresholds.
min. 20 cm min. 20 cmmax. 30 cm
Produced by Danfoss A/S © 04/2009
VICSB202
7 8
Lighter constructions require the insulation to be glued at the perimeter,
under SpeedUp header panels and through thresholds.
Second or third layers of insulation must always be cross-laid to the ones
below. The last layer must be cross-laid to SpeedUp heat panels above.
9 10
Enclose pipe section (maximum width 30 cm according to BEB/ZDB
Information leaflet) and fill up with bonded compound level with insulation.
Pipe sections with insulated pipes and above 20 cm must be covered
with a 1 mm metal sheet. *
Protect insulation from frequent pedestrian traffic to avoid damage.
*Note! For light floor constructions (e.g. when laying laminate/parquet
directly on the heat panel and all strongboard constructions) pipe
channels - in the additional insulation - with a width of more than 10 cm
must be covered with a metal plate (min. 1 mm). If the pipe channels
have a width of more than 15 cm a special loadbaring plate (min. 18 mm)
must be used.
Instruction Installation of additional insulation EPS / XPS for SpeedUp
/
