2. FSR
  3. SW-DG-SLT
SW-DG-SLT

FSR SW-DG-SLT User manual

  • Hello! I have reviewed the SW-DG-SLT Installation Instructions. This document provides detailed guidance on how to install the product, including mounting to the raceway base, routing wires, and installing block off plates. It specifies the importance of using correct voltage devices in appropriate compartments and also lists the product's various ratings and specifications. I'm ready to answer any questions you have about it.
  • What is the first step for mounting the box on the raceway end?
    What should be done after routing wire and cables?
    How do you install the cover?
    What is the minimum storage temperature?
    What is the application temperature range?
244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
SW-DG-SLT Installation Instructions
LIT187943460
!
!
NOTICE: For installation by a qualified electrician in accordance with all national and local electrical codes and communications
standards. Adhere to the following instructions and any instructions included with the individual raceway components.
C
Classification; CTS/DTS 3.102 Flushfloor, 3.103 Onfloor, 6.101.1 Dry-Treatment Only, 6.2.6 10J Impact
6.102.3 1,000 N Small Surface Load, 6.4.1 Non-Flame Propagating
IP41; Min Storage Temp - 25 C; Installation and Application Temp - 15 C to 60
CAUTION: Ensure Edge Of Raceway Cover Is Deburred.
Install box chassis to raceway base. End kit & raceway base edge must be installed first if 1.
mounting box on raceway end.
Route wires and cables and install high voltage block off plates as required.2.
Install cover with supplied screw.3.
On Raceway Base End
Compartments
Raceway Base Edge
(Included With Raceway Base)
WARNING:
To Raceway Base
Use Low Voltage
(2) Cover Screw
Base) Must Be Installed Prior To
Devices Only In
High Voltage
Devices Only In
Compartments
Electrical Box Mounting If Box Is Installed
(2) Screw To Secure Box
(Sold Separately)
Raceway Base
Low Voltage
Box Chassis
Cover
End Kit (Sold Separately) & Raceway
Base Edge (Included With Raceway
WARNING: Use High Voltage
Install (2) Block Off Plates
As Required To Maintain
Circuit Separation
/