Extron TSP Series User manual

Brand: Extron

Model: TSP Series

Category: Screen protectors

Type: User manual

Extron electronics TSP Series are tempered glass TLP Screen Protectors that can minimize damage to the touchscreens of Extron TouchLink Touchpanel models.

The TSP Series is available in three sizes to fit the following TouchLink models:

TSP 1: TLP Pro 525C, TLP Pro 525M, TLP Pro 525T, TLS 525M, and TLC Pro 526M
TSP 2: TLP Pro 725C, TLP Pro 725M, TLP Pro 725T, TLS 725M, and TLC Pro 726M
TSP 3: TLP Pro 1025M, TLP Pro 1025T, TLS 1025M, and TLC Pro 1026M

The TSP Series is easy to install and can be removed

Extron electronics TSP Series are tempered glass TLP Screen Protectors that can minimize damage to the touchscreens of Extron TouchLink Touchpanel models.

The TSP Series is available in three sizes to fit the following TouchLink models:

TSP 1: TLP Pro 525C, TLP Pro 525M, TLP Pro 525T, TLS 525M, and TLC Pro 526M
TSP 2: TLP Pro 725C, TLP Pro 725M, TLP Pro 725T, TLS 725M, and TLC Pro 726M
TSP 3: TLP Pro 1025M, TLP Pro 1025T, TLS 1025M, and TLC Pro 1026M

The TSP Series is easy to install and can be removed

TSP Series • Installation Guide

The Extron TSP 1, TSP 2, and TSP 3 are tempered glass TLP Screen Protectors that

can minimize damage to the touchscreens of Extron TouchLink Touchpanel models:

• TSP 1 — TLP Pro 525C, TLP Pro 525M, TLP Pro 525T, TLS 525M, and

TLC Pro 526M

• TSP 2 — TLP Pro 725C, TLP Pro 725M, TLP Pro 725T, TLS 725M, and

TLC Pro 726M

• TSP 3 — TLP Pro 1025M, TLP Pro 1025T, TLS 1025M, and TLC Pro 1026M

To attach the screen protector:

NOTE: If the touchpanel has already been mounted, Extron recommends

removing the touchpanel and placing it on a at, stable surface before

installing the screen protector.

1. Clean the touchpanel screen thoroughly, using an alcohol wipe.

2. Wipe the screen with a microber cloth to ensure it is dry and, if required, use

dust remover to ensure no dust or other particles remain.

3. Place the touchpanel on a flat surface and ensure that it cannot move while the

screen protector is being attached.

4. Peel the backing film away from the screen protector.

NOTE: Do not touch the adhesive surface of the screen protector.

TSP Series • Installation Guide (Continued)

68-3447-01 Rev. B

12 19

All trademarks mentioned are the property of their respective owners.

Worldwide Headquarters: Extron USA West, 1025 E. Ball Road, Anaheim, CA 92805, 800.633.9876

5. Hold the screen protector by the edges and at a shallow angle to the screen of

the touchpanel (

6. Align the edge of the screen protector with the edge of the touchpanel

screen (

), so that the corners are close to the rounded corners of the

touchpanel screen.

NOTE: The margin around the perimeter is approximately 0.02" (0.5 mm) on

each of the four sides.

7. Lower the raised edge of the screen protector onto the touchpanel screen.

NOTE: If you need to reposition the screen protector, carefully lift one corner

and reposition it. Do not touch the adhesive.

8. To remove any air bubbles, use your thumbs to apply gentle pressure to the

screen from the center outwards, pushing the air bubbles to the edge.

Extron TSP Series User manual

Brand: Extron

Model: TSP Series

Category: Screen protectors

Type: User manual

Extron electronics TSP Series are tempered glass TLP Screen Protectors that can minimize damage to the touchscreens of Extron TouchLink Touchpanel models.

The TSP Series is available in three sizes to fit the following TouchLink models: