Elecom PM-A19BZEROBK Installation guide

Elecom
Brand
Elecom
Model
PM-A19BZEROBK
Category
Screen protectors
Type
Installation guide

This manual is also suitable for

Before Installing
CAUTIOUS
How to Replace or Remove the Screen Protector
Smartphone
Screen
Protector
Protective
Layer
Green
Top Laye
Bubbles
How to Apply a Screen Protector
Please ensure it fits exactly and perfectly on the screen.
Be careful not to install on the camera part, sensor, front
speaker or other part except the screen.
The installation may fail if the screen is wet, or dirty.
If the dust is remaining before applying the protector,
it may cause damaging the screen.
Please be sure you don’ t touch the film adhesive surface.
The edge of the screen might be curved depending on the model.
If so, avoid the curving part and apply the protector.
Structure of the Protector
Green
Top Laye
Screen
Protector
Protective
Layer
Curving Part
Protective Layer
Please be sure to line up the screen protector in correct way.
<Preparation>
Use the alcohol wipe to thoroughly
clean your screen, and then use
the microfiber cloth to give it one last
polish for good measure.
Make sure your phone is turned off.
<Remove the Protective Layer>
Peel half of the protective layer.
<Alignment>
Make sure to align the protector
with the display portion of your
screen. The glass should line up
evenly with the front speaker and
home button, and it should run
parallel with the screen length-wise
<Remove the Bubbles>
Once you decide where to put the protector,
peel the rest of the protective layer and install
the protector on the screen.
<Peel the Green Surface Sheet>
Finally, take off the green top layer and
pull the screen protector back.
PLEASE NOTE: Be careful not to peel the
screen protector as well.
Tips for Perfect Installation
How to Remove the Bubbles
If there are giant bubbles, use finger or a piece of tape
or card to pull up one corner of the film and reapply it.
It is Airless type that adopted special adsorption layer
becomes inconspicuous air bubbles with the passage
of time.
The bubbles may not disappear in terms of its size.
Please do not press the screen too hard in order not
to crack the screen.
Apply a piece of tape to the corner and lift the protector.
tape
  • Page 1 1

Elecom PM-A19BZEROBK Installation guide

Elecom
Brand
Elecom
Model
PM-A19BZEROBK
Category
Screen protectors
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents