Page is loading ...
Parts
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:signware@rosedisplays.com
Instructions for Hanging
Instruction Sheet
Instructions for Hanging
Incept-10.5.00
The Gotcha® is a registered trademark and GotchaClip is a trademark of
Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be
held liable for injury, loss or damage resulting from the use of these
products. Part #00INSGotchaClip/Pegboard
Instructions for Hanging
GotchaClip™ for Pegboard
Step 1
Place poster on a flat surface. Snap the Gotcha
Holder open and insert poster (top and bottom).
To close, snap the Gotcha Holder shut. Fig. 1
Note: It is easier to open and close the Gotcha
Holder by starting at one end and working your
way down the holder.
Step 2
Insert the GotchaClips into the holes in the peg-
board. For best results, place the GotchaClips in
holes separated by a difference equal to half of the
length of Gotcha Holder. ( i.e. If holder is 12” place
clips 6” apart). Fig. 2
Step 3
Push Gotcha onto clips, you will hear a “SNAP”.
Fig. 3
Important note:
Please save and reuse the Gotcha Holder and
GotchaClips for future projects.
Gotcha
12G100
GotchaClips
for Pegboard
Figure 1
Figure 2
Figure 3
Parts
Instructions for Hanging
Instruction Sheet
Instructions for Hanging
Incept-10.5.00
The Gotcha is a registered trademark and GotchaChips are a trademark of
Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be
held liable for injury, loss or damage resulting from the use of these
products. Part #00INSGotchaClip/Pegboard
Instructions for Hanging
GotchaClip™ for Pegboard
Step 1
Place poster on a flat surface. Snap the Gotcha
Holder open and insert poster (top and bottom).
To close, snap the Gotcha Holder shut. Fig. 1
Note: It is easier to open and close the Gotcha
by starting at one end and working your way down
the holder.
Step 2
Insert the GotchaClips into the holes in the
pegboard. For best results, place the GotchaClips
in holes separated by a difference equal to half of
the length of Gotcha Holder. ( i.e. If holder is 12”
place clips 6” apart). Fig. 2
Step 3
Push Gotcha onto clips, you will hear a “SNAP”.
Fig. 3
Important note:
Please save and reuse the Gotcha Holder
and GotchaClips for future projects.
Gotcha
12G100
GotchaClips
for Pegboard
Figure 1
Figure 2
Figure 3
/
