Robertshaw Slip-fit® Dial (For 4200 Series) User manual

Brand: Robertshaw

Model: Slip-fit® Dial (For 4200 Series)

Type: User manual

Robertshaw Slip-fit® Dial (For 4200 Series) allows for precise temperature control in various applications. After mounting the control, you can customize the dial's "low-stop" position and index pointer alignment. The blank dial and temperature scale insert ensure easy setup and a clean look. Installation is simple, but requires careful alignment of the tabs to ensure proper fit. The dial can be removed for cleaning or replacement of the temperature scale insert.

INSTALLATION DATA

Slip-fit

dial

(for 4200 SerieS)

Customer Service Telephone 1.800.304.6563

Customer Service Facsimile 1.800.426.0804

[email protected]

Robertshaw®, Ranco®, Paragon® and Uni-Line® are

trademarks of Robertshaw, its subsidiaries and/or

affiliated companies. All other brands mentioned

may be the trademarks of their respective owners.

For Technical Service

Telephone 1.800.445.8299

Facsimile 1.630.260.7294

[email protected]

www.uni-line.com

www.robertshaw.com

09/14 – 1-211 RevB

1. Mount the new kit control according to

 theinstruconsheet.

2. Aerthecontrolisinstalled,placethe

 blankdialontothedialsha.Turnthedial

 clockwiseunlitstops.Thisisthe

 “low-stop”posion.

3. Decidewhichdireconyouwantthe

 “low-stop”posion(thewordRobertshaw)

 onthedialtoread;up,right,leordown.

If the index pointer is desired, and it needs

to be located to match the “low-stop”

 posionofthedial,seetheinstrucons

packaged with the control.

4. Take a pencil and lightly mark on the

outside edge of the blank dial where the

 “low-stop”posionisgoingtobe.

5. Removetheblankdialandplaceitonaat

surface. Take the temperature scale insert

and hold it over the dial, lining up the

word Robertshaw with the pencil mark.

DO NOT PUSH, but let it fall down onto the

knob. STOP! DO NOT PUSH THE INSERT

YET.

6. THIS STEP IS VERY IMPORTANT AND

MUST BE FOLLOWED CAREFULLY. READ

THIS WHOLE SECTION BEFORE

PROCEEDING FURTHER. Make sure that

 “low-stop”(thewordRobertshaw)isgoing

 tobeinthecorrectposion.Makesure

 thatallfourtabs(seegure2)tinsidethe

edge of the blank dial. If one tab is slightly

 o,useangernailandbenditinslightly.

Double check to see that all the tabs now

 tinsideoftheblankdial.Slowlypressthe

 insertallthewaydown(seegure2).

7. If removal of the temperature scale insert

 isnecessary,pullthedialoofthedial

 sha.Usingasmallbluntobject,likeadull

pencil point, push out the insert using the

 tworemovalopeningsprovided(see

 gure1).

“LOW-STOP”

POSITION

(THEWORD

ROBERTSHAW)

LOCATING RIBS

(FOUR)

REMOVAL

OPENING

BLANK

DIAL

TEMPERATURE

SCALEINSERT

FIGURE 1 FIGURE 2

TAB TAB

Robertshaw Slip-fit® Dial (For 4200 Series) User manual

Robertshaw Slip-fit® Dial (For 4200 Series) User manual

Robertshaw Slip-fit® Dial (For 4200 Series) User manual

Related papers