07.01.2013 Page 1 of 5
OPTIc2 Driver installation (Windows 7)
1. Connect the ALGE USB Stick to your PC. If you do not have an ALGE USB Stick,
you have to download the driver from the Alge Homepage www.alge-timing.com.
After downloading the driver, you have to extract it: press unzip
2. Connect the OPTIc2 with your PC and connect the power supply.
Windows 7 x86: Please wait until Windows finished searching for the driver. If you
have an Alge-CD, Windows should find the driver automatically.
Windows 7 x64 resp. on install failure: Continue with 3.
3. Open the device manager by pressing start\Control Panel\Hardware and
Sound\Device Manager
Make a double-click on “Alge-Timing&OPc2” (or right-click and properties)
07.01.2013 Page 2 of 5
4. Click to “Update Driver”
5. Click to “Browse my computer for driver software”
07.01.2013 Page 3 of 5
6. Click to “Browse”
7. Then choose the driver location and click “ok” and “next”
07.01.2013 Page 4 of 5
8. Please confirm that you really want to install this driver and click to “Install this
driver software anyway”
9. Click “Close”
07.01.2013 Page 5 of 5
10. You should get a message that the driver is correct installed. Click to “Close”
11. You can check now if the driver is correct installed.
-
1
-
2
-
3
-
4
-
5
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
ALGE-Timing TIMY Series User guide
-
ALGE-Timing OPTIc2 User manual
-
ALGE-Timing OPTIc2 User guide
-
ALGE-Timing WS2 User guide
-
ALGE-Timing GAZ5 User guide
-
ALGE-Timing OPTIc3.NET User guide
-
ALGE-Timing Optic User guide
-
ALGE-Timing MT1 User guide
-
ALGE-Timing Timy User guide
-
ALGE-Timing Time.NET User guide
