Beghelli ACCIAIO BX9102SE Installation guide

Beghelli
Brand
Beghelli
Model
ACCIAIO BX9102SE
Type
Installation guide
Page 1 of 2
Beghelli U.S.A., 3810 Executive Way, Miramar, Florida, Tel: (954) 442-6600
09/25/23
ACCIAIO® BX9102SE
INSTALLATION INSTRUCTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS:
1. CAUTION! ALWAYS MAKE SURE THE POWER IS TURNED OFF before starting installation.
2. Measure, locate xture’s position, and mark locations for the brackets.
3. Secure brackets to ceiling as shown below. (HARDWARE BY OTHERS)
4. Wiring xture to power supply, shall be performed by a certied electrician, and wired in a manner that complies with
all national electrical codes, as well as the manufacturer’s wiring diagram.
5. Proper replacement of a part removed for user maintenance.
SAVE THESE INSTRUCTIONS!
INSTALLATION
SAVE THESE INSTRUCTIONS!
10-32 SCREW
4X4 J-BOX (BY OTHERS)
J-BOX GASKET GROMMET
10-32 SCREW
10-32 LOCKNUT
WALL BRACKET
TRANSITION BRACKET
MOUNTING CLIP
8-32 SCREW
1. Attach the Mounting Clips on the Transition Brackets as shown.
2. Attach the Transition Brackets & Mounting Clips assembly to the Wall Bracket.
Snap the Fixture onto the Mounting Bracket.
3. Snap the Fixture onto the Mounting Bracket assembly.
4. Install Grommet on the Wall Bracket.
5. Feed the power cord through the Grommet and wiring to the J-box power source
(see wiring detail on second page).
6. Attach the entire assembly to the J-Box (hardware by others).
7. Go to second page for battery connection instruction before power up the fixture.
MOUNTING BRACKET CAN ACCOMODATE J-BOXES
BELOW (RECESSED ONLY)
• 2x4 J-Box.
• 2x4 Weather-proof J-Box.
• Round Weather-proof J-Box.
• 4” Octagonal J-Box.
• 4” Round J-Box.
180°
Page 2 of 2
Beghelli U.S.A., 3810 Executive Way, Miramar, Florida, Tel: (954) 442-6600
09/25/23
ACCIAIO® BX9102SE
INSTALLATION INSTRUCTIONS
REMOVING END CAP
CONNECTING THE BATTERY
SCREWS
TEST SWITCH
HOOK
CONNECT THE BATTERY
DIMMING WIRING DIAGRAM:
**BEFORE POWERING UP THE FIXTURE,
CONNECT THE BATTERY AS SHOWN TO THE
RIGHT
AC LEADS
BLACK......(HOT)
WHITE.......(NEUTRAL)
GREEN......(GROUND)
REMOVE SCREWS AND LIGHTLY
PULL OUT THE BOTTOM OF THE
COVER TO UNHOOK THE TOP OF
THE COVER
  • Page 1 1
  • Page 2 2

Beghelli ACCIAIO BX9102SE Installation guide

Beghelli
Brand
Beghelli
Model
ACCIAIO BX9102SE
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers