Beghelli CASTEX 300 (HZ-CAS300) Installation guide

Beghelli
Brand
Beghelli
Model
CASTEX 300 (HZ-CAS300)
Category
Wall & ceiling mounts accessories
Type
Installation guide
CASTEX 300
Page 1 of 5
Beghelli U.S.A., 3810 Executive Way, Miramar, Florida, Tel: (954) 442-6600
04/21/22
When using electrical equipment, basic safety precautions should always be followed including:
1. Disconnect power before performing work on electrical equipment.
2. Do not mount near gas or electric heaters.
3. Equipment should be mounted in locations and at heights where it will not be subjected to
tampering.
4. The use of accessory equipment not recommended by Beghelli Inc., may cause an unsafe
condition, and will void the unit’s warranty.
5. Do not use this equipment for other than its intended purpose.
6. Servicing of this equipment should be performed by a qualied service personnel.
7. Suitable for non-insulated surface and frame. DO NOT cover xture with insulation liner or
similar material.
8. DO NOT install in unstable, loose or breakable surfaces.
9. DO NOT let objects impact or exert force on the surface of the xture.
10. SAVE THESE INSTRUCTIONS!
Fixtures must be wired in accordance with National electrical code and all applicable local codes.
Proper grounding is required for safety.
This product must be installed in accordance with the applicable installation code by a qualied
electrician who is familiar with the construction and operation of the product and the hazards
involved.
IMPORTANT SAFEGUARDS
Read & Follow All Safety Instructions
INSTALLATION INSTRUCTIONS
CASTEX 300
Page 2 of 5
Beghelli U.S.A., 3810 Executive Way, Miramar, Florida, Tel: (954) 442-6600
04/21/22
WARNING
Risk of fire, electric shock or personal injury
Before installation, turn off power!
INSTALLATION STEPS (Ceiling Mount)
1. Take the xture and accessory out of packaging.
Then tighten both angle holder screws as shown
above.
2. Install the exible metal conduit and tighten it to the
xture.
3. Drill two holes in ceiling at a 91~140mm distance
apart (as shown above). Use ø10 expansion screws
to ax the bracket on the ceiling.
4. Connect the AC cable; black cable to L, white cable
to N, green cable to grounding.
CASTEX 300
Page 3 of 5
Beghelli U.S.A., 3810 Executive Way, Miramar, Florida, Tel: (954) 442-6600
04/21/22
WARNING
Risk of fire, electric shock or personal injury
Before installation, turn off power!
INSTALLATION STEPS (Wall Mount)
1. Take the xture and accessory out of packaging.
Then tighten both angle holder screws as shown
above.
2. Install the exible metal conduit and tighten it to the
xture.
3. Drill two holes in surface (as shown above) at a
91~140mm distance apart. Use ø10 expansion
screws to ax the bracket on the surface.
4. Connect the AC cable; black cable to L, white cable
to N, green to grounding.
CASTEX 300
Page 4 of 5
Beghelli U.S.A., 3810 Executive Way, Miramar, Florida, Tel: (954) 442-6600
04/21/22
WARNING
Risk of fire, electric shock or personal injury
Before installation, turn off power!
INSTALLATION STEPS (Pendant Mount)
1. Take the xture and pole accessory out of
packaging. Then screw pole into luminaire as shown
above.
2. Connect the AC cable to the junction box; black
cable to L, white cable to N, green to grounding.
Drill four ø10mm holes in chosen surface at 100mm
distance apart (as shown above).
3. Use ø10 expansion screws to install the junction
box to chosen surface. Screw pole into junction box
and adjust the chain support.
3/4 NTP: Tighten with
a minimum of 6x full
rotations (thread count).
Chain Support
CASTEX 300
Page 5 of 5
Beghelli U.S.A., 3810 Executive Way, Miramar, Florida, Tel: (954) 442-6600
04/21/22
WARNING
Risk of fire, electric shock or personal injury
Before installation, turn off power!
INSTALLATION STEPS (Hook Mount)
1. Take the xture and accessory out of packaging. 2. Screw the hook onto the xture. Tighten with a
minimum of 6x full rotations (thread count). Secure
the M3 locking screw to prevent the hook from
turning loose.
3. Drill one hole in ceiling for the expansion screw.
Install hook in ceiling. Attach chain to hook as
shown above.
4. Hang the luminaire on the hook as shown above.
Connect the AC cable; black cable to L, white cable
to N, green to grounding.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Beghelli CASTEX 300 (HZ-CAS300) Installation guide

Beghelli
Brand
Beghelli
Model
CASTEX 300 (HZ-CAS300)
Category
Wall & ceiling mounts accessories
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents