BLOTZ B28-SR-001 Assembly Instructions

28mm Stairs #1

B28-SR-001

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember

to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while

you allow glue to dry.

Remove the left-hand supports and the steps from

the sprue.

Glue the steps into the non-etched side of the

supports.

Then take the right-hand support and platform.

Glue them together as shown above.

Starting with the lugs on the platform, carefully

align these with the holes in the left-hand support,

then working down one step at a time, align these

with the holes in the right hand support.

Glue the base to the supports.

Note: Tthis only fits one way round.

Glue the end support into position.

Take the hand-rails from the sprue.

And glue these to the supports. The slightly

rounded end of the long rails should be at the

bottom of the steps.

Download PDF