2. BLOTZ
  3. B15-SR-001

BLOTZ B15-SR-001 Assembly Instructions

  • Hello! I have analyzed the provided instructions for the BLOTZ Stairs model B15-SR-001. This document guides you through assembling a detailed 15mm scale model stairs, using glue and a modeling knife. I am prepared to answer your questions about the assembly process and the features of this model.
  • What type of glue is recommended?
    What tool is needed to remove parts from the sprue?
    Is sanding required?
15mm Stairs #1
B15-SR-001
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the left-hand supports and the steps from
the sprue.
Glue the steps into the non-etched side of the
supports.
Then take the right-hand support and attach that
in position, gently easing each step into place.
Insert the lugs on the platform into the left hand
support, then gently ease the other side down onto
the pegs on the right hand support.
Add the base.
Glue the end support into position.
Add the top rail and handrails (rounded end
downwards).
/