2. Warrior Products
  3. 577

Warrior Products 577 Installation guide

  • Hello! I've reviewed the installation instructions for the Warrior Jeep YJ Rock Crawler Rear Bumper with Receiver, specifically models 575, 576, 577, and 580. This document explains how to remove your existing bumper and install the new bumper, and includes drilling and gas tank issues. I'm ready to answer any questions you have about the installation process or the product itself.
  • What size lock nuts are used for installation?
    Do I need to drill holes for installation?
    Do I need to lower the gas tank for installation?
Warrior, Inc.
11100 SW Industrial Way
Tualatin, OR 97062
Phone: (888) 220-6861
Fax: (503) 692-0364
customerservice@warriorproducts.com
www.warriorproducts.com
P/N: 575 / 576 / 577 / 580
INSTALLATION INSTRUCTIONS
1. Remove your existing bumper, or bumperettes, from your vehicle.
2. Install new bumper using the 7/16” lock nuts and washers provided. Washers should be
placed between the nut and the frame. On some models the inside bolt holes are not drilled.
You will need to align the bumper and drill holes 15/32” or ½”. The gas tank may or may not
need to be lower to install the inside nuts on to the bolts. It is difficult but can be done with
out lowering the tank.
3. After initial test drive, check all bolts for tightness. You should check all bolts for tightness
each time before using the receiver hitch for towing.
If you need further assistance installing your product, please contact us by email at
customerservice@warriorproducts.com or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS
/