Warrior Products 592 Installation guide

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone (888) 220-6861

Fax (503) 692-0364

JEEP WRANGLER JK REAR BUMPER

INSTALLATION INSTRUCTIONS

WAR 592/593

Installation:

1. Remove factory rear bumper - This is done by removing two 16mm bolts on either side of the

frame rail. The factory rear bumper will also have two braces bolted to the underside of the rear

cross member. Remove and discard these braces and hardware as they are no longer needed.

2. On factory hitch equipped vehicles, the bumper may need to be slightly modified to clear the

wiring plug bracket. Alternatively, the wiring plug bracket may be removed altogether.

3. Set bumper into place – Bolt into location with factory hardware. Ensure the bumper is aligned

and level, then tighten bolts.

4. Installation Complete - Your new bumper is now installed.

If you need further assistance installing your product, please contact us by email at

[email protected] or call us at (888) 220-6861.

THANK YOU FOR PURCHASING WARRIOR PRODUCTS

This manual is also suitable for

Download PDF