2. Warrior Products
  3. WAR505

Warrior Products WAR505 Installation guide

  • I have read the Warrior Products installation instructions for the Rear Bumper WAR 500, 505. This guide provides specific steps for mounting this bumper to CJ5, CJ7, TJ and YJ models, including the preparation and hardware requirements. I'm ready to help you with any questions related to this installation.
  • What models does this bumper fit?
    Do I need to drill holes for installation?
    What torque do I need to tighten the nuts to?
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
[email protected]
CJ5, CJ7,TJ, YJ REAR BUMPER
INSTALLATION INSTRUCTIONS
WAR 500, 505
Bumpers are designed to fit over existing rear cross member support.
1. Remove old bumper or “Bumperettes” from vehicle.
2. Be sure that area where bumper will be mounted is flat and free of any damage.
3. Some TJ’s only have two pre-drilled (2) holes on each side. If you are installing
a bumper on a TJ, you may need to drill two (2) additional holes on each side.
Measure from existing holes; mark with a center punch and drill with a 7/16”
drill. Be very careful not to drill into anything that may be behind cross member
support. I.e. gas tank cover, wiring. Wear safety glasses.
4. Install new bumper with enclosed hardware. Tighten 7/16” nuts to 50 ft/lbs.
Re-torque after your initial test drive.
5. If you have a hitch bumper, check the bumper bolts for tightness prior to and
after each use.
If you need further assistance installing your product, please contact us by email at
[email protected] or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS
/