Warrior Products 59015, 59010 Installation guide

  • I'm your chat assistant and I've reviewed the provided installation instructions for the Warrior Universal Brush Guard WAR 59000 SERIES. This document outlines the step-by-step process for mounting the brush guard on your vehicle's bumper, including drilling and bolt tightening. I am ready to answer any specific questions you have about the installation process or the product itself.
  • What size drill bit is needed for installation?
    What hardware is included for installation?
    What should be done after the initial installation?
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364
www.warriorproducts.com
UNIVERSAL BRUSH GUARD
INSTALLATION INSTRUCTIONS
WAR 59000 SERIES
READ ALL INSTRUCTIONS BEFORE PROCEEDING.
1. Position your Warrior Universal Brush Guard on the top flat surface of your
bumper. Take care to center it with mounting brackets adjusted forward or
back to accommodate your particular bumper design.
2. Mark through the mounting brackets for drilling.
3. Remove the Universal Brush Guard and drill 3/8” holes where indicated by
marks. Be sure to use safety glasses.
4. Reposition the Universal Brush Guard over the mounting holes and install
using the 3/8” bolts, washers, and lock nuts provided. Make sure all bolts are
tight.
5. After a test drive, re-check tightness of all bolts and you’re done!
Enjoy your new Universal Brush Guard by Warrior Products!
/