Power and signal cables for internal drives .............54
Removing an adapter ......................55
Installing an adapter .......................57
Removing a PCI card ......................59
Installing a PCI card .......................60
Removing a USB embedded hypervisor flash device ...........61
Installing a USB embedded hypervisor flash device ...........61
Removing the virtual media key...................62
Installing the virtual media key ...................63
Removing a hot-swap power supply .................64
Installing a hot-swap power supply .................65
Installing a security rope clip ....................66
Completing the installation.....................67
Reinstalling the two-piece bezel..................67
Reinstalling the side cover....................70
Connecting the cables .....................71
Updating the server configuration .................71
Connecting external devices ....................71
Chapter 6. Installing and replacing customer replaceable units .....73
Removing the rear system fan ...................73
Installing the rear system fan....................74
Removing the hard disk drive fan assembly ..............75
Installing the hard disk drive fan assembly ...............76
Removing the simple-swap backplate ................78
Installing the simple-swap backplate .................79
Removing the SAS/SATA hard disk drive backplane ...........81
Installing the SAS/SATA hard disk drive backplane............82
Removing the front-panel assembly .................83
Installing the front-panel assembly..................83
Removing the front USB connector assembly..............84
Installing the front USB connector assembly ..............85
Removing the rear adapter retention bracket ..............86
Installing the rear adapter retention bracket ..............86
Removing the front adapter-retention bracket ..............87
Installing the front adapter-retention bracket ..............87
Removing the hot-swap power supply cage ..............87
Installing the hot-swap power supply cage ...............88
Removing the battery ......................89
Installing the battery .......................89
Removing and replacing FRUs ...................90
Removing a ServeRAID BR10-il controller ..............91
Installing a ServeRAID BR10-il controller ..............91
Removing an optional ServeRAID-MR10i SAS/SATA controller ......92
Installing an optional ServeRAID-MR10i SAS/SATA controller .......92
Removing an optional ServeRAID-MR10is VAULT SAS/SATA controller . . . 94
Installing an optional ServeRAID-MR10is VAULT SAS/SATA Controller . . . 94
Removing a non-hot-swap power supply ..............96
Installing a non-hot-swap power supply ...............98
Removing the microprocessor and fan sink .............99
Installing a microprocessor and fan sink ..............101
Removing the system board ..................104
Installing the system board ...................106
Chapter 7. Configuring the server.................109
Using the Setup Utility ......................110
iv ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Installation and User Guide