Install faucet into sink by leading all hoses
down center through center hole. From
under sink, thread mounting nuts onto
faucet. Tighten mounting nuts.
Insert spray hose down through support and
sink. Attach spray hose to spray hose nipple.
Shut off water supply at angle stop . Remove
old faucet. Clean sink surface in preparation
for new faucet.
Insert sprayer support through far right-hand
hole on sink. Screw hold-down nut onto
shank and hand tighten.
Making the waterline connections:
Use 1/2 in. I.P.S. faucet connections (2, not
included), or use the coupling nuts (3, not
included) with a 3/8 in. O.D. ball-nose riser (1,
not included). Use wrenches when tightening.
Do not overtighten.
Important: After installation is completed,
remove aerator. Turn on water supply and
allow both hot and cold water to run for at
least one minute each. While water is
running, check for leaks. Replace aerator.
6.
4.
2.
5.
3.
1.
INSTALLATION STEPS: Two handle kitchen faucet
Cleaning:
To maintain and protect the fine luster of all products, clean with a soft, damp cloth
only. DO NOT USE detergents or cleansers as they may harm the protective finish.
INSTALLATION
Model Number: 119261 & 119262 & 119263
1
3
2
Brand Lavatory Faucets
Tools:
Adjustable wrench
Groove joint pliers
Pipe wrench
Screwdriver
Thread sealant tape
Basin wrench
Plumber's putty