Premier 7019-7001 Installation guide

Type
Installation guide

This manual is also suitable for

Insert spray hose down through support
and sink. Attach spray hose to spray
hose nipple.
Insert spray support through far right-hand
hole on sink. Screw hold-down nut onto
shank and hand tighten.
Shut off water supply at angle stop. Remove
old faucet. Clean sink surface in preparation
for new faucet.
Install faucet into sink by leading faucet
hoses and thread rod through the center
hole of sink. From underside, washer
and nut onto the thread rod and tighten
nut. Do not overtighten.
Making the waterline connections:
Use 1/2 in. I.P.S. faucet connections (2, not
included), or use the coupling nuts (3, not
included) with a 3/8 in. O.D. ball-nose riser (1,
not included). Use wrenches when tightening.
Do not overtighten.
NOTE: The hot side inlet tube is indcated by
a label.
Important: After installation is completed,
remove aerator. Turn on water supply and
allow both hot and cold water to run for at
least one minute each. While water is
running, check for leaks. Replace aerator.
6.
4.
2.
5.
3.
1.
INSTALLATION STEPS: Single handle kitchen faucet
Cleaning:
To maintain and protect the fine luster of all products, clean with a soft, damp cloth
only. DO NOT USE detergents or cleansers as they may harm the protective finish.
INSTALLATION
Model Number: 119258 & 119259 & 119260
1
3
2
Brand Lavatory Faucets
Tools:
Adjustable wrench
Groove joint pliers
Pipe wrench
Screwdriver
Thread sealant tape
Basin wrench
Plumber's putty
119258 & 119259 & 119260
386
1
8
Aerator
1
12
13
1
9
Clip
10
O-ring
Wearable Washer
152
1
45
150
387
5
Bonnet Nut
Cartridge
6
994658
1
1
1
1
Cap
4
3
1
1
MODEL NO.119258
PART DESCRIPTION
Handle Screw & Screw Cap
NO.
2
1
PART NO.
QTY.
1
1
Diverter
Sprayer, Hose & Cradle
59
195
1
1
11
14
15
Block
O-ring
1
390
129
110
104
6
1
2
3
4
5
7
8
9
10
11
12
13
14
15
Handle Assembly
388
7
Flange & Washer
389
Mounting Kits
394
QTY.
1
59
10
Diverter
Block
O-ring
Flange & Washer
Mounting Kits
Sprayer, Hose & Cradle
12
13
11
14
15
1
1
1
1
1
129
390
393
394
279
Bonnet Nut
Handle Assembly
Handle Screw & Screw Cap
PART DESCRIPTION
Aerator
O-ring
Wearable Washer
Cartridge
Cap
1
2
NO.
3
4
5
8
9
6
7
Clip
MODEL NO.119259
994658
387
392
105
111
1
1
PART NO.
1
1
1
1
1
1
1
391
152
45
150
QTY.
1
59
10
Diverter
Block
O-ring
Flange & Washer
Mounting Kits
Sprayer, Hose & Cradle
12
13
11
14
15
1
1
1
1
1
129
390
397
394
366
Bonnet Nut
Handle Assembly
Handle Screw & Screw Cap
PART DESCRIPTION
Aerator
O-ring
Wearable Washer
Cartridge
Cap
1
2
NO.
3
4
5
8
9
6
7
Clip
MODEL NO.119260
994658
387
396
334
336
1
1
PART NO.
1
1
1
1
1
1
1
395
152
45
150
www.premierfaucet.com, [email protected]
  • Page 1 1
  • Page 2 2

Premier 7019-7001 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI