2. Emtek
  3. Square and Round Pocket Mortise Lock

Emtek Square and Round Pocket Mortise Lock Installation guide

  • Hello! I've reviewed the installation guide for the EMTEK Square and Round Pocket Mortise Lock. This document provides instructions for threading the cylinder, installing the lock body, and trim plates, along with door jamb prep. I am ready to answer any questions you have about the installation process.
  • What tool is used to thread the drive bar cylinder?
    What is important about the Drive Bar Socket position during installation?
    What must be parallel when the cylinder is fully installed?
Installation Guide - Square and Round Pocket Mortise Lock - Privacy
IN4-SQRDPCKTMRTPRIV-INS REV. 3 2-12-21
See template for door prep
Round trim
shown
Square trim
shown
Threaded
Tube
1. Thread Drive Bar Cylinder
Inside
4. Tighten Key Cylinder
3. Install Inside and Outside Plates
Note: Drive Bar Socket must
be in the 12 o’ clock position
as shown.
Cylinder Key
Note: Notches on cylinder must be
parallel with the horizontal plane
when fully screwed into lock body.
Use Cylinder Key to thread Drive Bar
Cylinder clockwise on interior side of
door.
2. Install Lock Body
Outside
Tighten locking screw
to engage notches on
cylinder
5. Install Trim Plate Door Jamb Prep.
See template for door jamb
Align Passage/Privacy button with Thumb-turn
spindle and secure trim pates to door.
/