Extron TLP Pro 725M Template

Brand: Extron

Model: TLP Pro 725M

Type: Template

This manual is also suitable for

Cut-out Template for the Extron

TLP Pro 725M, TLS 725M, and TLC Pro 726M Series

SURFACE

CUT-OUT

AREA

3.50" (89 mm)

2.00"

(51 mm)

Page size: 8.5" x 11"

Print scale 1:1

Do not shrink.

P/N 68-3206-01 Rev. B

1. Confirm the product to be

installed.

2. Before printing, double-check the

print settings and make sure the

page is not scaled.

3. After printing, measure the gray

dotted line to make sure it has

the dimensions shown.

4. Cut the red line and remove the

surface cut-out area (gray) from

the template.

5. Place the template. Use a level to

ensure it is at the correct angle

and make sure that there is

enough room for the touchpanel.

6. Mark the position on the

mounting surface where the

touchpanel is being installed.

7. Double-check dimensions and

position, then cut the opening.

For complete installation instructions,

see the TLP Pro 525M, 725M, and

1025M Series Setup Guide or TLC Pro

526M, 726M, and 1026M Series Setup

Guide (at www.extron.com).

Outer edge of touchpanel (Do not cut)

5.05" H x 7.12" W (128 mm H x 181 mm W)

Extron TLP Pro 725M Template

Brand: Extron

Model: TLP Pro 725M

Type: Template

This manual is also suitable for

Download PDF

report

Extron TLP Pro 725M Template

This manual is also suitable for

Extron TLP Pro 725M Template

Related papers

Other documents