2. Otter Outdoors
  3. Universal Rear Sled Hitch Receiver

Otter Outdoors Universal Rear Sled Hitch Receiver Assembly Instructions

  • Hello! I've reviewed the instructions for the Sled Hitch Receiver 200064. This document outlines how to install the hitch on Otter Pro and Otter Wild sleds, including measurements, drilling, and bolt-tightening steps. I'm ready to answer any questions you have about the installation process or the product features.
  • What are the differences in measurements for Otter Pro and Otter Wild sleds?
    What drill bit size is recommended for the initial hole?
    What size bolt is required to secure the receiver?
Rear Sled Hitch Receiver Instructions Item 200064 (0403)
1. At the rear of the Otter Pro sled measure down 7” from the underside of the lip at the
approximate center. For the Otter Wild sled measure down 8”. Place a mark at this spot.
Now measure the width of the sled where the mark is and mark the center point. In this
case the sled is 32” wide, 7” down from the lip, so the center point is at 16”.
2. From the center point measure 3/4” to the left and place a mark. Drill a hole at that
mark using an 11/32” drill bit or just over 5/16”. Place the hitch receiver into position
and put a 5/16 bolt through the receiver and the hole. Lightly tighten into place. Make
sure the receiver is level and then drill out the second hole.
7” down
Otter Pro
7” down
Find the center point
Center pointMark and
drill hole ¾”
from the
center point
Insert bolt and
lightly tighten here
Drill second hole
here thru the
hole in receiver
8” down
Otter Wild
3. Remove the bolt from the receiver and line up the inside backing plate with the holes
in the sled and the holes in the receiver. Insert the bolts and washers through the inside
plate and the receiver and tighten down using the nylock nuts.
/