Minka Group N2031-1 User manual

Minka Group
Brand
Minka Group
Model
N2031-1
Type
User manual
INSTALLATION INSTRUCTIONS
Item#N2031-1 (New. 05/30/2023)
READ AND SAVE THESE INSTRUCTIONS
WA R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig.1
Fig. 2
MOUNTING THE FIXTURE (Fig. 1)
1. Shut off power at the fuse box or circuit breaker box and
remove the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts
in a clear area. Take care not to misplace any small parts
necessary for installation.
3. Thread all thread (E) into crossbar (C). Note: The length
of all thread (E) into crossbar (C) may be adjusted, if
necessary.
4. Secure all thread (E) to crossbar (C) using lock washer
(B) and hex nut (A).
5. Take the crossbar assembly (C) and mount it to outlet box
(not included) with mounting screws (D) (Size:
#8-32N*L0.5”). The side of crossbar marked with “GND”
must face out.
CONNECTING THE WIRES (Fig. 2)
6. Connect the electrical wires as shown in Fig. 2, making
sure that all wire connectors are secured. If your outlet
box has a ground wire (green or bare copper), connect
the fixture’s ground wire to it. Otherwise, connect fixture’s
ground wire directly to crossbar (C) using green screw
provided.
7. After wires are connected, tuck them carefully inside
outlet box.
COMPLETING THE INSTALLATION (Fig.1)
8. Place backplate (F) over all thread (E) and secure with
finial (I).
9. Secure Backplate (F) on Poly Shade (J) by tightening
threaded Screws (G) into two openings of Poly Shade (J)
as shown Fig.1.
10. Install (1) one medium base bulb (H) up to 60 watts each
or CFL or LED equivalent (not included) in accordance
with the fixture specification—DO NOT EXCEED THE
MAXIMUM WATTAGE RATING! (NE PAS DEPASSER
LA PUISSANCE NOMINALE MAXIMALE!).
Your installation is now complete. Return power to the
junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-3705E
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
Set
#
A
-
0
10
- Crossbar
- Ground screw
- Mounting Screw
*2
MIN 75℃ SUPPLY CONDUTORS
A
B
C
D
H
G
E
J
I
F
  • Page 1 1

Minka Group N2031-1 User manual

Minka Group
Brand
Minka Group
Model
N2031-1
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents