2. George Kovacs
  3. P1704-613

George Kovacs P1704-613, P1704-647 User manual

  • Hello! I am an AI chatbot trained to assist you with the George Kovacs P1704-613 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
INSTALLATION INSTRUCTIONS
Item#P1704-613/647 (New.03/01/2012)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 2
Fig. 1
MOUNTING THE BACKPLATE (Fig.1)
1. Shut off the power at the circuit breaker and
remove the old fixture, including the mounting
hardware.
2. Carefully unpack your new fixture and lay out all
the parts on a clear area. Take care not to lose
any small parts necessary for installation.
3. Attach the crossbar to the junction box with
mounting screws (size: #8-32N*L0.5”). The side of
the Crossbar marked “GND” must face out.
4. Thread the nipple part way into the center hole of
the crossbar. Note: The length of the nipple into the
crossbar may by adjusted if necessary.
CONNECTING THE WIRES (Fig. 2)
5. At this point, connect the electrical wires as shown
in Fig. 2, making sure that all wire connectors are
secured. If your outlet box has a ground wire
(green or bare copper), connect the fixture’s
ground wire to it. Otherwise, connect the fixture’s
ground wire directly to the mounting plate using
the green screw provided. After wires are
connected, tuck them carefully inside the junction
box.
MOUNTING FIXTURE AND SHADE
6. Place the glass shade (B) over the fixture body (D)
and secure with screws (A).
7. Place the fixture body (D) over the nipple and
secure with cap nut (C).
8. Install the A19 1*100W (MED BASE) light bulb
(not included) in accordance with fixtures
specifications. (DO NOT EXCEED MAXIMUM
WATTAGE RATING!) (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power
to the junction box and test the fixture.
Note: Illustration (Fig.1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare
Copper(Gr
ound)
MIN 90℃ SUPPLY CONDUCTORS
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY
A QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
Set# A-016
-Crossbar
-Ground screw
-Mounting Screw*2
C
B
D
A
F
Wire connector
Junction box
(Wall)
Crossbar
Junction box screw
nipple
/