2542-726

Minka Lavery 2542-726 User manual

  • Hello! I've reviewed the installation instructions for the light fixture 2542-726. This document provides guidance on how to install the fixture, connect the wires, and install the bulbs. I am ready to answer any of your questions regarding the installation process or the features of this device.
  • What should I do before installing the new fixture?
    What is the size of the mounting screws?
    How many bulbs can be installed in this light fixture and what type?
INSTALLATION INSTRUCTIONS
Item#2542-726 (New. 02/18/2022)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig.1
Fig. 2
MOUNTING
THE FIXTURE (Fig. 1)
1. Shut off power at the fuse box or circuit breaker box and
remove the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts
in a clear area. Take care not to misplace any small parts
necessary for installation.
3. Thread all thread (E) into crossbar (C). Note: The length
of all thread (E) into crossbar (C) may be adjusted, if
necessary.
4. Secure all thread (E) to crossbar (C) using lock washer
(B) and hex nut (A).
5. Take this crossbar assembly (C) and mount it to outlet box
(not included) with mounting screws (D) (Size:
#8-32N*L0.5”). The side of crossbar marked with “GND”
must face out.
CONNECTING THE WIRES (Fig. 2)
6. Connect the electrical wires as shown in Fig. 2, making
sure that all wire connectors are secured. If your outlet
box has a ground wire (green or bare copper), connect
the fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the crossbar (C) using the
green screw provided. After the wires are connected, tuck
them carefully inside the outlet box.
COMPLETING THE INSTALLATION (Fig.1)
7. Place fixture body (F) over all thread (E) and secure with
finial (G)
8. Install (2) two medium base T10 bulb (I) up to 60 watts
each or CFL or LED equivalent (not included) in
accordance with the fixture specification DO NOT
EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS
DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
9. Place glass shade (J) over socket (H).
Your installation is now complete. Return power to the
junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
LA-3510E
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
#
A
-
0
10
- Crossbar
- Ground screw
- Mounting Screw*2
E
G
F
I
J
H
A
B
C
D
/