Minka-Lavery 734-355 User manual

Brand: Minka-Lavery

Model: 734-355

Type: User manual

Minka-Lavery 734-355 is a lighting fixture designed to be mounted on a ceiling. It includes a backplate, crossbar, nipple, shade support tube, threaded screws, knurled cap, and shade. The fixture can be used with a variety of light bulbs, but the maximum wattage rating should not be exceeded. The fixture is easy to install and includes all necessary hardware. The fixture can be used in a variety of settings, including homes, offices, and businesses.

INSTALLATION INSTRUCTIONS

05/10/2012

READ AND SAVE THESE INSTRUCTIONS

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Fig. 1

Fig. 2

MOUNTING THE BACKPLATE (Fig.1)

1. Shut off the power at the circuit breaker and remove old

fixture, including the mounting hardware

2. Carefully unpack your new fixture and lay out all the parts on

a clear area. Take care not to lose any small parts necessary

for installation.

3. Attach the Crossbar to the junction box using two Junction

Box Screws. The side of the Crossbar marked “GND” must

face out.

4. Thread the Nipple part way into the center hole of the

Crossbar.

CONNECTING THE WIRES (Fig. 2)

5. At this point, connect the electrical wires as follows: Connect

the black wire from the fixture to the black house (hot) wire.

Connect the white wire from the fixture to the white (neutral)

house wire; Make sure all wire nuts are secured. You may

wrap the connections with electrical tape. If you outlets have

a ground wired (green or bare copper) connect fixture’s

ground wire to it. Otherwise connect fixture’s ground wire

directly to the crossbar using the green screw provided. Tuck

the wire connections neatly into the ceiling junction box.

MOUNTING FIXTURE AND SHADE (Fig.1)

6. After the wires are connected, carefully tuck them inside the

junction box as you place the Backplate over the nipple.

Secure the Backplate against the wall using Hex Nut or

Knurled Cap.

7. Place the Shade to the Backplate, matching the Threaded

Screws on Shade Support Tube to the holes on either side of

the shade.

8. Secure the assembly by adjusting the Threaded Screws

outwards at each side of the Shade Support Tube until it is

wide enough for the shade to be properly supported.

9. Install light bulbs in accordance with fixture specifications,

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING!)

(NE PAS DEPASSER LA PUISSANCE NOMINALE

MAXIMALE!)

Your installation is now complete. Return power to the junction

box and test the fixture.

Note: Illustration (Fig. 1) on this manual is for

installation purposes only. It may or may not be

identical to the fixture purchased.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black

(Hot)

FIXTURE

WIRES

White or

Ribbed

HOUSE

WIRES

White

(Neutral)

FIXTURE

WIRES

Green or

Bare

Copper

(Ground)

HOUSE

WIRES

Green

(Ground)

LA-799E

Shade

Knurled Cap

Threaded Screws

Shade Support Tube

Wire Nut

Back plate

Nipple

Junction Box Screw

Crossbar

Junction Box

Minka-Lavery 734-355 User manual

Minka-Lavery 734-355 User manual

Minka-Lavery 734-355 User manual

Related papers

Other documents