Metropolitan N7352-790 User manual

Brand: Metropolitan

Model: N7352-790

Type: User manual

Metropolitan N7352-790 is a versatile lighting fixture designed to enhance the ambiance of various spaces. With its adjustable all-thread, it offers customizable installation lengths to suit different ceiling heights. The fixture accommodates two candelabra base bulbs, allowing for a total of 120 watts of illumination. It supports incandescent, CFL, or LED bulbs, providing energy-efficient lighting options. The Metropolitan N7352-790 is a stylish and adaptable lighting solution for both residential and commercial applications.

INSTALLATION INSTRUCTIONS

Item#N7352-790 (New. 10/13/2021)

READ AND SAVE THESE INSTRUCTIONS

W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

Fig. 1

PREPARATION (Fig. 1)

1. Shut off power at the fuse box or circuit breaker box and remove

the old fixture including the mounting hardware.

2. Carefully unpack your new fixture and lay out all the parts in a

clean area. Take care not to misplace any small parts necessary

for installation.

ASSEMBLING THE FIXTURE (Fig. 1)

3. Secure crossbar (A) to junction box (Not included) with mounting

screws (B) (Size: #8-32N*L1”). The side of crossbar marked

“GND” must face out.

4. Thread one end of all thread (C) into crossbar (A), tighten with lock

washer and hex nut. The length of all thread (C) may be adjusted if

necessary.

CONNECTING THE WIRES (Fig. 2)

5. Connect the electrical wires as shown in Fig. 2, making sure that

all wire connectors are secured. If your junction box has a ground

wire (green or bare copper), connect the fixture’s ground wire to it.

Otherwise, connect the fixture’s ground wire directly to the

crossbar (A) using the green screw provided.

6. Tuck wire connections neatly into junction box.

COMPLETING THE INSTALLATION (Fig. 1)

7. Place back plate (G) of fixture body (F) to all thread (C) and secure

with finial (D).

8. Install (2) two candelabra base bulbs (E) up to 60 watts each or

CFL or LED equivalent (not included) in accordance with the

fixture specification.

—DO NOT EXCEED THE MAXIMUM WATTAGE RATING!

(NE PAS DEPASSER LA PUISS

ANCE NOMINALE

MAXIMALE!).

Your installation is now complete. Return power to the junction

box and test the fixture.

Note: Illustration (Fig. 1) on this manual is for installation

purposes only. It may or may not be identical to the fixture

purchased.

Page:1/1

Set#A-010

- Crossbar

- Ground Screw

- Mounting Screw *2

Acrylic pole#

GP7352-1 *4

GP7352-2 *2

GP7352-3 *4

Fig. 2

Metropolitan N7352-790 User manual