Sunricher SR-2501DIN User manual

Sunricher
Brand
Sunricher
Model
SR-2501DIN
Type
User manual

Sunricher SR-2501DIN is a universal series RF Receiver that can be controlled by a push switch, LED output, or a remote control that operates at 868/915/434MHz radio frequency. It has four channels, each of which can output a constant voltage or current, making it suitable for use with a variety of lighting fixtures. The device can be paired with up to eight remote controls and can be set to operate in either single-zone or multi-zone mode. It also features a push dimming function, which allows users to adjust the brightness of the connected lights by holding down the push switch.

Sunricher SR-2501DIN is a universal series RF Receiver that can be controlled by a push switch, LED output, or a remote control that operates at 868/915/434MHz radio frequency. It has four channels, each of which can output a constant voltage or current, making it suitable for use with a variety of lighting fixtures. The device can be paired with up to eight remote controls and can be set to operate in either single-zone or multi-zone mode. It also features a push dimming function, which allows users to adjust the brightness of the connected lights by holding down the push switch.

V-V+
+
1-2-3-4-
Power input
Learning key
RF Receiver
V-V+
DC INPUTLED OUTPUT
Push Switch
GND
V- V+
connect With
single color lighting
V- V+
V-V+
+
1-2-3-4-
Power input
Learning key
RF Receiver
V-V+
DC INPUTLED OUTPUT
Push Switch
GND
Universal series RF Receiver 09.2501D.04091
PUSH
SWITCH
Waterproof grade: IP20
Radio Frequency : 868/915/434mhz
Function introduction
Important: Read All Instructions Prior to Installation
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
Size(LxWxH)
110x53x65mm
110x53x65mm
110x53x65mm
Product Data
Safety & Warnings
Operation
Wiring Diagram
Input
Voltage Remarks
Output
Current
12-36VDC Constant voltage
4x(60-180)W
4x5A
Output
Power
12-36VDC Constant current
4x(4.2-12.6)W
4x350mA
12-36VDC Constant current
4x(8.4-25.2)W4x700mA
No.
1
2
3
V-V+
+
1-2-3-4-
Power input
Learning key
RF Receiver
V-V+
DC INPUTLED OUTPUT
Learning Key:
Paring with RF remote
DC Power inputDC Power input
Common Anode Output(+)
CH 1 output(-)
CH 2 output(-)
CH 3 output(-)
CH 4 output(-)
V- V+
connect With
single color lighting
Do wiring according to connection diagram.
Pair RF Receiver with RF remote:
1. Connect and wire up the RF receiver correctly, power on.
2. Turn on the remote, click the “Learning Key” button on receiver, immediately click a zone number to pair the
receiver to the specified zone if the remote is a multi-zone controller (if it is a single zone remote, this step is
unnecessary), then touch the color wheel or slider bar on the remote (if the remote does not have color wheel or
slider bar, click or touch any keys), the connected led light on receiver flickers twice, which means well paired.
Note: one receiver can be paired with max 8 remote controls.
Delete the pairing:
1. Wire up the RF receiver correctly, power on.
2. Hold down the “ Learning Key” button on receiver for over 3 seconds until the connected led light on
receiver flickers twice, which means well deleted.
PUSH DIM:
When connected to Push Switch, click push switch for switch ON/OFF,hold push switch to dim up/down the
brightness
L
N
G
V+
V-
OUTPUT
INPUT
AC Power
50/60Hz
12V/24V/36V
CV PSU
V- V+
Push Switch
GND
Push switch
input
Can be controlled by
push switch
If you use multiple receivers, you have two choices:
Option 1: have all the receivers in the same zone, like zone 1
Zone 1
Option 2: have each receiver in a different zone, like zone 1, 2, 3 or 4
Zone 1 Zone 2 Zone 3
RF remote
RF remote
V-V+
+
1-2-3-4-
Pow er inpu t
Lea rning k ey
RF Rec ei ver
V-V+
DC IN PUTLED O UTPUT
Pus h Switc h
GND V-V +
+
1-2-3-4-
Pow er inpu t
Lea rning k ey
RF Rec ei ver
V-V+
DC IN PUTLED O UTPUT
Pus h Switc h
GND
V-V+
+
1-2-3-4-
Pow er inpu t
Lea rning k ey
RF Rec ei ver
V-V+
DC IN PUTLED O UTPUT
Pus h Switc h
GND V-V +
+
1-2-3-4-
Pow er inpu t
Lea rning k ey
RF Rec ei ver
V-V+
DC IN PUTLED O UTPUT
Pus h Switc h
GND V-V +
+
1-2-3-4-
Pow er inpu t
Lea rning k ey
RF Rec ei ver
V-V+
DC IN PUTLED O UTPUT
Pus h Switc h
GND
  • Page 1 1
  • Page 2 2

Sunricher SR-2501DIN User manual

Sunricher
Brand
Sunricher
Model
SR-2501DIN
Type
User manual

Sunricher SR-2501DIN is a universal series RF Receiver that can be controlled by a push switch, LED output, or a remote control that operates at 868/915/434MHz radio frequency. It has four channels, each of which can output a constant voltage or current, making it suitable for use with a variety of lighting fixtures. The device can be paired with up to eight remote controls and can be set to operate in either single-zone or multi-zone mode. It also features a push dimming function, which allows users to adjust the brightness of the connected lights by holding down the push switch.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents