2. Sunricher
  3. SR-1009CS3

Sunricher SR-1009CS3, SR-1009CS, SR-1009CS7, SR-2501NS, SR-2502NS, SR-2503NS User manual

  • I have reviewed the user manual for the Sunricher Universal series RF Receiver 09.009CS.04007. This document provides details on how to set up and use the RF receiver, which can be controlled via both RF remote and push switch. The manual explains the pairing process, dimming functionalities, and different output options. I am here to assist you with any questions you may have about the RF Receiver described in the user manual.
  • How do I pair the RF receiver with a remote?
    How many remotes can be paired with the receiver?
    How can I delete the pairing?
RF Receiver
Lea rning K ey
GND
Pus h
Swi tch
Waterproof grade: IP20
Radio Frequency : 868/915/434mhz
Learning Key:
Paring with RF remote
Function introduction
Important: Read All Instructions Prior to Installation
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
1 CH output
Size(LxWxH)
95x37x20mm
95x37x20mm
95x37x20mm
Product Data
Safety & Warnings
Do wiring according to connection diagram.
Pair RF Receiver with RF remote:
1. Connect and wire up the RF receiver correctly, power on.
2. Turn on the remote, click the “Learning Key” button on receiver, immediately click a zone number to pair the
receiver to the specified zone if the remote is a multi-zone controller (if it is a single zone remote, this step is
unnecessary), then touch the color wheel or slider bar on the remote (if the remote does not have color wheel or
slider bar, click or touch any keys), the connected led light on receiver flickers twice, which means well paired.
Note: one receiver can be paired with max 8 remote controls.
PUSH DIM:
When connected to Push Switch, click push switch for switch ON/OFF,hold push switch to dim up/down the
brightness
Delete the pairing:
1. Wire up the RF receiver correctly, power on.
2. Hold down the “ Learning Key” button on receiver for over 3 seconds until the connected led light on
receiver flickers twice, which means well deleted.
Operation
AC Power
50/60Hz
12V/24V/36V
CV PSU
L
N
G
V+
V-
OUTPUT
INPUT
If you use multiple receivers, you have two choices:
Option 1: have all the receivers in the same zone, like zone 1
Zone 1
Option 2: have each receiver in a different zone, like zone 1, 2, 3 or 4
Zone 1 Zone 2 Zone 3
RF remote
RF remote
Universal series RF Receiver Wiring Diagram
Input
Voltage Remarks
Output
Current
12-36VDC Constant voltage
1x(96-288)W
1x8A
Output
Power
12-36VDC Constant current
1x(4.2-12.6)W
1x350mA
12-36VDC Constant current
1x(8.4-25.2)W1x700mA
No.
1
2
3
Can be controlled by
push switch
09.009CS.04007
RF Receiver
Learn ing Key
GND
Push
Switch
DC Power input
Push switch
V+ V+
V- V-
PUSH
RF Re cei ver
Learn ing Key
GND
Push
Swit ch
RF Re cei ver
Learn ing Key
GND
Push
Swit ch
RF Re cei ver
Learn ing Key
GND
Push
Swit ch
RF Re cei ver
Learn ing Key
GND
Push
Swit ch
RF Re cei ver
Learn ing Key
GND
Push
Swit ch
/