2. BLOTZ
  3. B20-ME-109

BLOTZ B20-ME-109, B20_ME_109, BH0-ME-109 Assembly Instructions

  • Hello! I have reviewed the user manual for the BLOTZ Desert Fort model B20-ME-109. This document provides clear step-by-step instructions on how to assemble the ruined wall model, including the use of PVA glue and a modeling knife. I'm ready to answer your questions about this model and its assembly.
  • What type of glue is needed for assembly?
    What tools are needed?
    What should I consider while using a sharp modelling knife?
20mm Desert Fort – Ruined Wall
B20-ME-109
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the pieces shown above from the sprue.
Turn the “roof” upside down and attach the other
pieces to it as shown.
Add the wall piece.
Add the front wall.
Attach the base, slotting each lug into the
associated hole.
Take the pieces shown above from the sprue.
Turn the “roof” upside down and attach the other
pieces to it as shown.
Add the front wall.
Attach the base, slotting each lug into the
associated hole.
The finished model.
/