Legrand 1x8 Enhanced Telecom Module, IS-0198 Installation guide

Brand: Legrand

Model: 1x8 Enhanced Telecom Module, IS-0198

Type: Installation guide

INSTRUCTION/INSTALLATION SHEET

ENHANCED TELECOM MODULES IS-0198 REV.B

1. Introduction

The On-Q Home Enhanced Telecom Modules (Figure 1) provide a

modular, structured method for distributing up to four (4) lines of

telephone service.

2. Description

The On-Q Home 1x8 Enhanced Telecom Module provides an

RJ45 modular jack for connecting and distributing incoming

telephone service to eight (8) room locations. A twenty-position

posted connector and .250” spade terminal are provided for

optional surge protection (P/N 363487-01). The 1x8 Enhanced

Telecom Module provides a modular jack, labeled BRIDGE, for

testing and bridging connections. Also provided is a modular jack,

labeled SECURITY, for interfacing to security systems.

Where additional capacity is required, the On-Q Home 8 Port

Telecom Expansion Module provides RJ45 modular jack

connections for up to eight (8) additional locations. Expansion

modules are connected via an RJ45 modular cable assembly

(included). Multiple expansion modules can be cascade

interconnected to provide telephone service to any number of

locations.

3. Installation

A. Mounting in Enclosure - See Figure 2

1) Align tabs on the module with slots on rail of enclosure.

2) Insert tabs angling module away from the back of the enclosure.

3) Rotate the module and insert fasteners on module into

corresponding holes on rail of enclosure. (Plunger must be in a

pulled position for fastener to engage hole)

4) Push plunger in to lock module in place. Pull on module to

ensure module is locked properly in place.

B. Incoming Service Cable Installation (1x8 Telecom)

1) Identify incoming service cable and route to RJ45 jack labeled

“Line In”.

2) Trim the cable to allow at least three (3) inches of excess cable

3) Terminate the cable with RJ45 modular plug (P/N 364405-01,

not included)

. Be sure to use proper terminating tool (P/N

364406-01).

Page 1 of 2

Middletown, PA 17057 www.onqhome.com

(800)-321-2343

Innovations in Home Living.

On-

Home

Enhanced 1x8 Telecom 364551-01

8 Port Telecom Expansion 364559-01

Figure 1

Figure 2

INSTRUCTION/INSTALLATION SHEET

ENHANCED TELECOM MODULES IS-0198 REV.B

C. Terminating the Outlet Cables

1) Route the cable to the RJ45 jack on the module.

2) Trim the cable to allow at least three (3) inches of excess cable.

3) Terminate the cable with RJ45 modular plug (P/N 364405-01, not included). Be sure to use proper

terminating tool (P/N 364406-01).

4) Plug cable into RJ45 Jacks, 1 through 8.

D. 8 Port Telecom Expansion Module

1) Mount the module below or next to the OnQ 1x8 Enhanced Telecom, as outlined in Section 3.A.

2) Connect outlet cables as outlined inSection 3.C.

3) Locate the category Jumper that is provided with the Module. Jumper from “BRIDGE” jack on the

Telecom Module to the “IN” jack on the Expansion Module.

E. Securing Cables

After all cables are connected to the module, the cables should be bundled and grouped to allow ease of

maintenance. On-Q Home Wire Management Straps, P/N 363491-01, may be used to bundle cable.

4. Testing

A. To test the outlet wiring from the Telecom Modules to the wall outlets, turn all switches on “Test Switch” to “OFF”.

Insert line tester into the RJ45 jack labeled “Bridge”. Perform check at each wall outlet. All outlets, including

those on the Telecom Expansion Module, will be testable.

B. To reset module to normal operation, ensure all switches are set to the “ON” position.

5. Other Applications

A. Security Interface

1) To enable line seizure and dial out capability to most security systems, connect the RJ31X cable (supplied

w/security system), to the RJ45 “Security” jack on the module. Turn Test Switch #1 to the OFF position to

activate the RJ31X. Connect the other end to the security systems as outlined in the security system

installation instructions.

2) To disable security, remove plug from “security” jack and set line 1 to “ON”.

B. Surge Protection

See instructions supplied with On-Q Home Surge Suppression Unit, P/N 363487-01.

Page 2 of 2

Middletown, PA 17057 www.onqhome.com

(800)-321-2343

Innovations in Home Living.

Legrand 1x8 Enhanced Telecom Module, IS-0198 Installation guide

Legrand 1x8 Enhanced Telecom Module, IS-0198 Installation guide

Legrand 1x8 Enhanced Telecom Module, IS-0198 Installation guide

Related papers

Other documents