Page is loading ...
1. Remove the battery cover. Insert 4 “C”
batteries. Replace the battery cover.
2. Bait the trap through the hole in the back wall
using a small amount of peanut butter, bacon,
dry pet food, nuts, etc. Be sure to use a Q-tip,
toothpick or another tool to bait so your scent
is not transferred onto the trap.
3. Place the trap where you have seen signs of
rodent activity or along the wall where rodents
primarily travel. The trap should be placed
lengthwise against the wall with the entrance
hole nearest the wall.
4. Turn on the trap – a green light will blink once
showing the trap is working properly.
5. A blinking green light will indicate a kill.
Dispose of the dead rodent, bait, reset and
place for continued rodent control.
Electronic Rat Trap
Instructions
1
5
2 3
4
www.victorpest.com
/