LED Tailgate Light Bar
User Manual
Important: Read all instructions prior to installation. TGL60S
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Rev Date: V1 12/10/2018
Safety and Notes Wiring Diagram
Installation Instructions
Dimensional Diagram
• To reduce risk of electric shock, ensure that battery is
disconnected before performing any installation procedures.
• Avoid looking directly into lamp when illuminated.
• Modications to the light or improper installation—not consistent
with guidelines of this document—will void warranty.
• Newer models (such as 2015+ Ford F-150s, 2017+ Ford Super
Duty trucks, and 2019+ GM trucks) will require a PWM adapter
to function properly. PWM adapter is not included, but can be
purchased separately (part number TGL60S-A).
1. Measure the lip under your vehicle tailgate to ensure there
is enough clearance to mount light bar.
2. Clean mounting surface with ≥90% isopropyl alcohol prior
to installation (not included).
3. Apply 3M Adhesion Promoter (not included, 06396 at
superbrightleds.com) to surface.
4. Mark area with a non-permanent media to create alignment marks.
5. Remove adhesive backing lm and attach light bar to surface.
6. Run power wire with at 4-pin connector behind your bumper
and connect to vehicles at 4-pin connection. Secure any slack
in the wire so it does not hang below bumper.
7. Locate power wire for reverse lights on vehicle harness and attach
reverse wire from light bar with splice tap (not included, IDC-2218
at superbrightleds.com)
Reverse Wire
10 A Fuse
Holder
Connect to vehicle
reverse light bulb
supply wire (+12 VDC).
59.25in
1504.95mm
39.53in
1004.06mm
41.07in
1043.18mm
1.80in
45.72mm
.79in
20.09mm
.35in
8.89mm
0.55in
13.97mm
0.4in
10.16mm
1.23in
31.24mm