2. superbrightleds
  3. FLT-X

superbrightleds FLT-X User manual

  • Hello, I've reviewed the user manual for the Flexible LED Tube Light FLT-x, WIFI-CON. This document provides instructions for installation, wiring (including non-vehicle and vehicle options), cutting to length, bending, and mounting. It is important to switch off the power before any installation or wiring. I'm ready to answer your questions about the device and how to operate it.
  • What should I do before installing or wiring?
    Is it safe to look directly at the light when illuminated?
    Where should I not install the light?
+
-
+
-
5-24V
Flexible LED Tube Light
WIFI-CON
User Manual
Important: Read all instructions prior to installation. FLT-x
Safety and Notes
Wiring (vehicle)
Wiring (non-vehicle)
• Warning: Switch o the supply power before any installation or wiring.
• Avoid looking directly at the light when illuminated.
• Do not install in a location that is in close proximity to a radiant heat source.
single tube with AC adapter and barrel connector
single tube with AC adapter, controller, and barrel connector
multiple tubes with cord, power supply, and connectors
+
-
+
-
+
-
5-24V
+
-
+
-
5-24V
+
-
+
-
5-24V
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Flexible LED Tube Light
WIFI-CON
User Manual
Important: Read all instructions prior to installation. FLT-x
Cutting to Length
1. Carefully remove attached end cap and strip from the wired end of the
tube/housing.
2. Cut strip to desired length using cut marks located on back of strip.
Note: Cuts must be made in order to remove the section opposite of the
wired end.
3. Use the section of strip that was removed to measure and trim length
of the tube/housing.
4. Slide strip back into tube/housing, making sure end caps are rmly in place.
Note: Silicone sealant can be used on the end caps for additional water
resistance as needed.
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Bending and Mounting
10cm
3.93in
/