Maxxima MRL-30900GUNWS Installation guide

Brand: Maxxima

Model: MRL-30900GUNWS

Type: Installation guide

Maxxima MRL-30900GUNWS is a 3-inch LED retrofit kit designed to upgrade recessed lighting fixtures with GU10 bulb sockets. It delivers 9 watts of power, emitting a bright and energy-efficient light output. Installation is simple and requires turning off the power, removing the existing bulb and trim, connecting the GU10 base to the socket, tucking wires into the housing, and pushing the LED trim flush against the ceiling. Compatible with various dimmers, the MRL-30900GUNWS offers customizable lighting control.

Maxxima MRL-30900GUNWS is a 3-inch LED retrofit kit designed to upgrade recessed lighting fixtures with GU10 bulb sockets. It delivers 9 watts of power, emitting a bright and energy-efficient light output. Installation is simple and requires turning off the power, removing the existing bulb and trim, connecting the GU10 base to the socket, tucking wires into the housing, and pushing the LED trim flush against the ceiling. Compatible with various dimmers, the MRL-30900GUNWS offers customizable lighting control.

Electrical parameters:

Installation Into Recessed Housing:

STEP1:

. Remove the existing diffuser,

bulb and trim as applicable.

STEP2: Connect GU10 base into socket

in housing. (Figure 1)

STEP3: Tuck all wires into the housing and

carefully p

and it is oriented as

needed for your installation (Figure 3)

Figure

3

2.

3" LED Retrofit-Kit Installation Instructions

ese instructions Type luminaires.

WARNING / ATTENTION

4.

5.

other

30900GUWS, MRL-30900GUNWS

08 9

1.

. Supply conductors (power wires) connecting to the fixture must be rated 90°C.

If uncertain consult an electrician.

3.

CAUTIONS

1. For your safety read and understand instructions completely before starting installation.

2.

Before attempting Installation, check your local electric code, as it sets wiring standards for

Figure 1

Figure 2

NOTES

qualified electrician.

your locality.

6. This lamp is not intended for use with emergency exit fixtures or emergency lights.

1. If luminaire (fixture) is to be switched from a wall switch, make sure black power supply wire

is connected to the switch. DO NOT connect the white supply wire to the switch.

2. Make sure no bare wires are exposed outside the wire nut connectors.

3.

during kits installation.

www.maxximastyle.com

Approved Dimmers

Leviton: 6672, 6674

Lutron: S-600P

, SLV-600P, CN-600P, DVWCL153P,

CTCL-153P, CTCL-153PR, DVCL-153PR, DVCL-253P

Maxxima: MEW-DM600, MEW-DM650

+RXVLQJ'LPHQVLRQV

2.85.5

Three Year Warranty:

Maxxima extends a 3 year limited warranty to the original purchase that the products listed are free from defects in material and/or

workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of

defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to

the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not

hereby assume any obligation whatsoever beyond sending a free replacement product.

1

Maxxima MRL-30900GUNWS Installation guide

Brand: Maxxima

Model: MRL-30900GUNWS

Type: Installation guide

Maxxima MRL-30900GUNWS is a 3-inch LED retrofit kit designed to upgrade recessed lighting fixtures with GU10 bulb sockets. It delivers 9 watts of power, emitting a bright and energy-efficient light output. Installation is simple and requires turning off the power, removing the existing bulb and trim, connecting the GU10 base to the socket, tucking wires into the housing, and pushing the LED trim flush against the ceiling. Compatible with various dimmers, the MRL-30900GUNWS offers customizable lighting control.

Related papers

Other documents