Maxxima MCL-711700BW Installation guide

Brand
Maxxima
Model
MCL-711700BW
Category
Motorcycle Accessories
Type
Installation guide

This manual is also suitable for

7” Round LED Ceiling Light Installation Guide MCL-711700
www.maxximastyle.com
FIXTURE MOUNTING AND WIRING INSTRUCTIONS
info@maxximastyle.com 866-MAXXIMA (629-9462) www.maxximastyle.com 125 Cabot Court Hauppauge, NY 11788
3 YEAR WARRANTY
Maxxima extends a 3 year limited warranty to the original purchase that the products listed are free from defects in material and/or
workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects
due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original
installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume
any obligation whatsoever beyond sending a free replacement product.
• Risk of electric shock - Disconnect power at the source
before installation.
• If you are unsure about the installation or the maintenance
of the wall light, please consult an electrician.
• Do not make or alter any holes in the wiring enclosure or
modify any electrical componentry.
CAUTIONS
• To insure personal safety, proper grounding of the
electrical fixture is required.
• The fixture must be wired in accordance with the National
Electric Code and applicable local codes or ordinances.
• Consult a qualified electrician to ensure correct branch
circuit conductor.
WARNINGS
1.
Ensure the power has been turned off by switching the circuit breaker
to the off position or by removing the fuse from the fuse panel.
2. If you are replacing an exisitng fixture, remove and disconnect
the old fixture first.
3. Mount the hanging bracket using the provided screws.
4. Connect the fixture ground wire (green/yellow) to the supply
ground (green or bare copper) using the provided wire nut.
5. Connect the fixture neutral wire (white wire) to the supply
neutral wire (white wire) using the provided wire nut.
6. Connect the fixture hot wire (black wire) to the supply hot wire
(black wire) using the provided wire nut.
7. Mount the fixture frame to the mounting bracket using the
provided nuts while ensuring no wires are being pinched or
misplaced.
8. Tighten the provided nuts until the fixture is tight agaist the
ceiling.
9. Attached the lens to the mounting frame by aligning the tabs,
and rotating the lens clockwise until secure.
10. Installation is now complete, restore power and
ensure the fixture is operational.
  • Page 1 1

Maxxima MCL-711700BW Installation guide

Brand
Maxxima
Model
MCL-711700BW
Category
Motorcycle Accessories
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents