Page is loading ...
CON4Z/CON8Z/CON12Z
50.0033.01.01 1/2
4/8/12 ZONES CONSOLE
FUNCTION
CONSOLE ASSIGNED TO SEND SPOKEN MESSAGES IN THE SELECTED ZONES RESPECTING THE PRIORITIES SYSTEM
AND WITH OPTIONAL CHIME.
DESCRIPTION
Dispose the following elements:
• Goose neck electret microphone
• Compressor to keep the voice level constant independently of the distance
microphone - mouth.
• Line balanced output (It is not necessary coaxial cable).
• BUSY indicator for same or higher priority messages.
• Optical indicator and/or chime acoustic monitor to know when to start speaking.
• Lockable push button with led indicator to know the assigned zones.
• Key to assign the message to all the zones at the same time.
• Easy installation with only two telephone wires and two RJ45 connectors (8 and 6
ways respectively).
• When using 8 or 13 zones one or two additional wires with 4 ways RJ45 connectors will be necessary.
FEATURES
INDICATORS:
POWER ON
: System ON
PAGING
: Message being sent by the sound system
BUSY
: System busy
CHIME
: CHIME being sent by the sound system
ZONE
: Zones selected
EXTERNAL
CONFIGURATIONS:
CHIME TYPES
: None, one, two or three tones
MONITOR CHIME
: on, off
INTERNAL
CONFIGURATIONS:
CHIME LEVEL
CONTROLS:
PAGE
: Push to speak
ZONE SELECTOR
: Keys selection zones 1, 2, 3, 4, All.
The 8/12 zones consoles will bring the according keys.
CONNECTIONS:
A
: Connector RJ45 6 pins to connect to module MCT12
D
: Connector RJ45 8 pins to connect to module MCT12
In the 8/12 zones modules there one or two additional 4-ways RJ45 connector.
CONNECTING THE 4/8/12 ZONES CONSOLE
To connect the console to the chassis link module, MCT12, refer to this module connecting notes.
You only have to consider that depending on the console model (4, 8 or 12 zones), you have to respect following connection table:
Connectors
A
B
C
D
4-zone console
YES
-
-
YES
8-zone console
YES
YES
-
YES
12-zone console
YES
YES
YES
YES
Inside the console you can only configure the chime type, its volume and whether to monitorize the chime through the console or
not.
CON4Z/CON8Z/CON12Z
2/2 50.0033.01.01
These settings have to be performed partly with the DIPSWITCHES, found on the consoles rear panel, according to following
table:
Chime Type
SW 1
SW 2
None
OFF
OFF
One tone
ON
OFF
Two tones
OFF
ON
Three tones
ON
ON
Monitor Chime
SW 3
ON
ON
OFF
OFF
In order to adjust the Monitor Chime volume, you will have to disassemble the console and set the volume by means of the pot
found inside.
/