BARRON QCRS Series Universal Red/Green Installation guide

Brand
BARRON
Model
QCRS Series Universal Red/Green
Type
Installation guide
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations
if applicable.
• Do not mount near gas or electrical heaters.
• Do not use outdoors.
• Equipment should be mounted in locations and at heights (MAX: 9ft) where it will not be readily subjected to
tampering by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Any modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
• Allow battery to charge for 24 hours before first use.
SAVE THESE INSTRUCTIONS!
Technical Support ■ (623) 580-8943 ■ [email protected]
QCRS Series
Installation Instructions
10070232 REV 1 - 01/21 800-533-3948 www.barronltg.com
1
Ceiling Mount
1. Make electrical connections; see Electrical Connections section.
2. Fasten J-box mounting plate to J-box.
3. Fasten canopy to J-box mounting plate.
4. Snap enclosure to canopy.
5. Connect and trim input leads to socket leads at upper left corner of housing wire channel.
6. Mount two remote lamp heads at most.
7. Secure faceplate to enclosure and remove chevrons, as desired.
Wall Mount
1. Make electrical connections; see Electrical Connections section.
2. Remove necessary knockouts and fasten backplate to J-box.
3. Snap enclosure to backplate.
4. Connect and trim input leads to socket leads at upper left corner of housing wire channel.
5. Mount two remote lamp heads at most.
6. Secure faceplate to enclosure and remove chevrons, as desired.
QCRS Series
Installation Instructions
10070232 REV 1 - 01/21 800-533-3948 www.barronltg.com
2
Operation
1. The unit is shipped from the factory with the color selector jumper set to “RED” (see Fig. 3 - jumper is placed across
pins 2 & 3) and use the red diffuser.
2. To change the color to “GREEN,” move the color selector jumper to “GREEN” (see Fig. 4 - jumper is placed across
pins 1 & 2) and use the green diffuser.
Electrical Connections (Fig. 5 & 6)
All electrical connections should be made inside the junction box. Make electrical connections as follows:
Note: Cap unused leads to prevent shorting.
120VAC 277VAC
White - Common White - Common
Black - 120VAC Red - 277VAC
Fig. 5 - Standard Models Fig. 6 - Remote Capable Models
Fig. 3 - Red Color Selection Fig. 4 - Green Color Selection
QCRS Series
Installation Instructions
10070237 REV 1 - 01/21 800-533-3948 www.barronltg.com
3
  • Page 1 1
  • Page 2 2
  • Page 3 3

BARRON QCRS Series Universal Red/Green Installation guide

Brand
BARRON
Model
QCRS Series Universal Red/Green
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents