Astonica 50101040 User manual

Type
User manual

This manual is also suitable for

OUTDOOR LIVING
Read the instructions and precautions before use of this product
MODEL NO: 50101014
Please keep this instruction manual for future reference
Made in China
© 2002 Distruibuted by:
World Factory, Inc.®
Southlake, TX
1-888-422-7800
Limited Warranty
World Factory, Inc.® Products for Home Use
World Factory, Inc.® (Seller) warrants to the original Buyer only, that each Astonica™ Product will be free
from defects in material and workmanship for a period of one (1) year from date of purchase. SELLER’S
SOLE OBLIGATION AND BUYER’S EXCLUSIVE REMEDY UNDER THIS LIMITED WARRANTY SHALL
BE THE REPAIR OR REPLACEMENT OF PARTS, WITHOUT CHARGE, WHICH ARE DEFECTIVE IN
MATERIAL OR WORKMANSHIP. ANY PARTS AS DETERMINED BY THE SELLER WHICH HAVE BEEN
MISUSED; ABUSED OR DAMAGED EITHER DIRECTLY OR INDIRECTLY FROM REPAIRS OR
ALTERATIONS ATTEMPTED BY UNAUTHORIZED PERSONS; IMPROPER MAINTENANCE, NEGLECT
OR ACCIDENT ARE NOT COVERED BY THIS LIMITED WARRANTY. This warranty does not apply to
damage, heat-induced coloration changes, scratching or alteration due to normal use or weathering.
To make a claim under this Limited Warranty, you must return the complete product, transportation prepaid,
to any World Factory, Inc.® authorized service center. Call 1-888-422-7800 for the location of the nearest
authorized service center.
Additional Limitations
THIS LIMITED WARRANTY DOES NOT APPLY TO ACCESSORY OR CONSUMABLE ITEMS RELATED
TO THIS PRODUCT. ALL IMPLIED WARRANTIES SHALL BE LIMITED IN DURATION TO ONE (1) YEAR
FROM DATE OF PURCHASE. IN NO EVENT SHALL SELLER BE LIABLE FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LIABILITY FOR LOSS OF PROFITS,
ARISING FROM THE SALE OR USE OF THIS PRODUCT.
If any provision of this Limited Warranty is for any reason held to be invalid or unenforceable, such
provision shall not affect any other provision herein, this Limited Warranty shall be construed as if such
invalid and/or unenforceable provision had never been contained herein.
This Warranty contains the entire agreement between Seller and Buyer and supersedes any and all prior
agreements, arrangements, or understandings between the parties relating to product warranty.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER, CONTACT CUSTOMER SERVICE AT
1-888-422-7800.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER, CONTACT CUSTOMER SERVICE AT
1-888-422-7800.
Orchid Inlay Arch-Back
Garden Bench
Instruction Manual
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-422-7800.
Carefully remove the contents from the package.
If any parts are missing do not attempt to use the product until
they have been obtained and correctly installed.
ASSEMBLY INSTRUCTIONS
Caution: Do not over tighten fasteners.
FIGURE 1
FIGURE 2
C
A
F
F
C
B
F
E
I
H
G
G
H
F
H
G
I
E
G
H
J
G
H
J
F
D
I
I
I
I
I
B
C
G
H
F
A
F
F
G
H
J
G
H
J
A
G
H
I
B
D
E
F
2. (SEE FIGURE 2) Attach the wood slats (B)
to the arm and leg support (C) as shown.
Repeat on the other side and do not tighten
bolts until all wood slats (B) are in place and
bench is at 90 degrees with floor.
1. (SEE FIGURE 1) Using Bolts (E) washers (F)
and nuts (G) attach one end of the Arched
Bench Back (A) to the Cast Iron Leg (C).
Attached the other end of the back to the
second leg & arm brace (C).
3. (SEE FIGURE 3) Turn the bench over on a
non-scratch surface and attach middle
support bracket (D) to the slats (B) at the
midway point between legs (C) using wood
screws (H). Work from the top to bottom,
bending bracket (D) as necessary to fit the
contour of the bench.
4. Ensure all fasteners are securely tightened.
FIGURE 3
D
H
C
5. (SEE FIGURE 4) Attach the side brackets (E)
to the leg & arm braces (C) using bolts (F)
washers (G) and nuts (H). Align the other
end of brackets (E) with the center of a wood
slat and fasten with wood screws (I).
6. Ensure all fasteners are securely tightened.
FIGURE 4
E
I
H
F
G
C
E
PARTS & HARDWARE LIST
PART # DESCRIPTION QUANTITY
A 1Arched Bench Back
B 5Wood Seat Slats
C 2Cast Iron Legs & Arm Brace
D 1
Side Support Brackets
Middle Support Bracket
E 2
6mm x 32mm Bolt
F 16
6mm Washer
G 16
6mm Nut
H 16
Phillips Wood Screw
I
Plastic Nut Cover
J
7
4
F
  • Page 1 1
  • Page 2 2

Astonica 50101040 User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI