Hobart Undercounter Stand Kit Installation guide

Hello! I've reviewed the installation instructions for the Hobart Centerline & Ecoline EW-798006 Dishwasher Stand. This document outlines the process of attaching the stand to a compatible dishwasher, detailing steps like preparing the stand, aligning the dishwasher and securing it with bolts. I'm ready to answer your questions regarding the use of this document.
What should be done before starting the installation?

What is the first step in the installation?

What should be done after aligning the mounting holes?

INSTALLATION INSTRUCTIONS

Centerline & Ecoline Undercounter Stand Instructions

These instructions are only intended for use by properly trained and qualified service technicians.

If you do not have technical training for this product, you should read the following procedure, in its entirety, to

determine if you have the necessary tools, instruments and skills required to perform the procedure. Procedures for

which you do not have the necessary tools, instruments and skills should be performed by a trained Hobart Service

technician.

The reproduction, transfer, sale or other use of this manual, without the express written consent of Hobart Service,

is prohibited.

NOTE: These instructions are to attach the Centerline or Ecoline stand to the Centerline or Ecoline dishwasher.

CENTERLINE & ECOLINE STAND KIT - EW-798006

Part Number Description QTY

EW-040138 Stand. 1

EW-486042 M8x20 SST Hex Bolt. 4

EW-H.602305 D8 SST Lock Washer. 4

NOTE: If any feet are installed on dishwasher, remove and discard.

WARNING

Disconnect the electrical power to the machine and follow lockout / tagout procedures.

1. Remove back cover from stand (1, Fig. 2).

2. Open front cover of stand (2, Fig. 2).

Before After

Fig. 1 Fig. 2

3. Lift dishwasher (1, Fig. 3) onto stand (2, Fig. 3) and align mounting holes.

Fig. 3

NOTE: Align front of dishwasher (1, Fig. 4) to front of stand (2, Fig. 4), as shown.

Fig. 4

4. Install bolts and washers from stand (2, Fig. 5) to dishwasher (1, Fig. 5).

Fig. 5

5. Reinstall back panel to stand.

6. Close front panel to stand.

F45842 Rev. A (September 2022) Page 2 of 2