Focal Point Seem 1 Direct Suspended / Surface Mount FSM1S Installation guide

Focal Point
Brand
Focal Point
Model
Seem 1 Direct Suspended / Surface Mount FSM1S
Type
Installation guide

This manual is also suitable for

IS0679 REV. G ©2022 Focal Point, LLC | 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com/reference 1 of 2
Seem® 1 Suspended
FSM1S | FSM1BS
• Congurationsarerunspecic,
pleaseconsultfactorydrawings
beforebeginninginstallation.
• Luminaires must be installed by a qualied
electrician (check with local and national
codes for proper installation).
• To prevent electrical shock, disconnect
electrical supply before installation or
servicing.
• Contractor is responsible for adequately
reinforcing walls and/or ceilings to support
xture weight.
• Focal Point, LLC accepts no responsibility
for inadequately reinforced walls and/or
ceilings.
• The information contained in this drawing
is the sole property of Focal Point, LLC.
Any reproduction in part or whole without
the written permission of Focal Point, LLC
is prohibited.
POWER OFF
POWER ON
ATTENTION
SEE ADDITIONAL
INSTRUCTIONS
BEFORE YOU BEGIN COMPONENT KEY
INSTRUCTION KEY
U - Individual
S - Start of run
I - Intermediate
E - End of run
Flush Lens
Asymmetric Lens
Pop-Down Lens
( Individual housings only, up to 8')
FOCAL POINT SHIPPED INSTALLED
Joiner
(A46895-01)
Alignment Plate
(A46949-01)
Alignment Plate Screw
8-32 x 7/8"
(700366)
Joiner Screw
10-32 x 3/4"
(700365)
Product ID label
on reector
Asymmetric Lens Distribution Direction
ASYMMETRIC DISTRIBUTIONS
INDIRECT ASYMMETRIC DIRECT/INDIRECT ASYMMETRIC
Standard Application Example Standard Application Example
Wall Wall
Power Feed Power Feed
Asymmetric Optic
Distribution Direction
Asymmetric Optic
Distribution Direction
Asymmetric Lens
Distribution Direction
Asymmetric Optic
Distribution Direction Asymmetric Optic
Distribution Direction
Asymmetric Optic
Distribution Direction
Asymmetric Lens Distribution Direction
Asymmetric Lens Distribution Direction
Asymmetric Optic
Distribution Direction
IS0679 REV. G ©2022 Focal Point, LLC | 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com/reference 2 of 2
INDIVIDUAL INSTALLATIONS FOLLOW STEPS 1 & 2
21
4
Two cable grippers each for individual and
start, one for intermediate and end housings.
Follow Focal Point instructions for
Universal Suspension System assembly.
See IS0166
MAKE ELECTRICAL CONNECTION
WIRE NUTS
BY OTHERS
3
5
7 8
11
6
DO NOT OVERTIGHTEN.
Note: Screw head may not seat to bracket. Seat screw rmly.
DRIVER SERVICE
1 2
Avoid all contact with LED surface,
LEDs are easily damaged!
Alignment Plate
Screw (700366) Joiner Screw
(700365)
  • Page 1 1
  • Page 2 2

Focal Point Seem 1 Direct Suspended / Surface Mount FSM1S Installation guide

Focal Point
Brand
Focal Point
Model
Seem 1 Direct Suspended / Surface Mount FSM1S
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents