Kamstrup Antenna Quick start guide

Brand
Kamstrup
Model
Antenna
Category
Signal cables
Type
Quick start guide
External antenna for heat meter
When meters for reading the heat consumption have been
installed, there may, in cases where meters are placed
inappropriately, be a need for mounting an external antenna.
To mount an external antenna on a heat meter, you must use the following three products
that enable you to adapt the solution to the individual installation.
Antenn dpter Antenna adapter for heat meters
5000292 Antenna adapter for antennas with SMA connectors so that
it fits the MCX connector on the module.
Antenn cble Extension cable for antenna that is mounted between the
SMA connector and the antenna
5000429
5000441
5000442
5000443
5000444
Super low-loss SMA extension cable
SMA (male) for SMA (female)
Length:
5 m
10 m
15 m
20 m
25 m
Externl ntenn The antenna is selected on the basis of cable length.
By default, antenna 6699484 is selected
Mini tringle
ntenn
6699448
6699484
6880013
Kamstrup's best 2G/3G antenna, which can also be used
with Wireless M-Bus.
Frequency areas: 868/900/1800/1900/2100 MHz
Can be mounted outdoors or indoors, typically on a wall or
a metal cabinet.
With 2.5 m cable, MCX connector (male)
With 1.5 m cable, SMA connector (male)
With 0.1 m cable, SMA connector (male) for the extension
up to 25 m*
Noe: The 2.5 m cable cannot be combined with extension cables, whereas the 1.5/0.1 m cables should be combined with
extension cables.
Kmsrup A/S · Industrivej 28, Stilling · DK-8660 Skanderborg · T: +45 89 93 10 00 · F: +45 89 93 10 01 · [email protected] · kamstrup.com
58116639_B1_GB_03.2021
  • Page 1 1

Kamstrup Antenna Quick start guide

Brand
Kamstrup
Model
Antenna
Category
Signal cables
Type
Quick start guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents