2. BLOTZ
  3. B10-CS-401

BLOTZ B10-CS-401, B10_CS_401 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Helipad and Lift B10-CS-401 model. This document details the assembly process, including gluing the edge pieces, steps, and lift components. I'm here to answer any questions you might have about constructing this model.
  • What glue is recommended for this model?
    What tools are required for assembly?
    Can I use pegs or elastic bands during assembly?
10mm Helipad and Lift
B10-CS-401
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Helipad and Lift (B10-CS-401)
Remove the landing pad, the edges and step
pieces from the sprue.
Glue the seven identical edge pieces around the edge
of the landing pad using the lugs provided.
Take the two step pieces and glue them together,
then attach the handrail section to them as
shown above.
Glue the edge piece with the space in it into place on
the landing pad, and glue the steps into position as
shown.
The lift is formed from the pieces shown above.
Glue the front and back pieces to the roof using the
lugs, the attach the end walls.
The finished helipad and lift.
/