General Toolbox
Compass
Cutting Pliers
6mm
Allen Key (A/F)
5mm
Allen Key (A/F)
17mm
Sockets (A/F)
Torque Wrench
17mm
Ring and Open spanner (A/F)
M10
(in MM)
Bolt Diameter
Tools Required
This antenna consists of a 0.6m (2ft) reflector,
Description.
results of improper or unsafe installation practices.
Andrew disclaims any liability or responsibility for the
equipment.
proper installation, maintenance, and condition of
inspected once a year by qualified personnel to verify
such personnel. Antenna systems should be
Andrew installation instructions have been written for
systems requires qualified, experienced personnel.
The installation, maintenance or removal of antenna
Notice.
Body Protection: Overalls.
Eye Protection: Glasses, if applied to parts in motion.
Hand Protection: Protective gloves for hypersensitive persons.
Respiratory Protection: None needed.
Skin: For hypersensitive persons, may irritate the skin after long periods of contact.
Ingestion: May cause diarrhoea.
Inhalation: Viscous nature may block breathing passages if inhaled.
Eyes: May cause irritation.
Main Hazards - Health Effects
Description
fine elevation and ± 180º (± 10º fine) azimuth.
4.5”). The mount provides adjustment ranges of ± 15º
vertical pipe of diameter 50mm to 115mm (1.9” to
The mount is designed to attach the antenna to a
tower mount.
shields, radome, attachment rims, feed and offset
Table 1. Parts List
Item Description Qty
1 Antenna Assembly 1
2 Mount bracket 1
3 Screw, M10 x 35lg Cs'k Hd, sst, pass 7
4 Saddle Washer 4
5Gloves 2
6 Mount Pivot bracket Assembly 1
7 Conductive Grease 1
8 Screw, M10 x 40lg Hex Hd, sst, pass 4
9 Lock Washer, M10, sst, pass 10
10 Washer, M10, sst, pass 10
11 Pipe Attachment Bracket 1
12 Screw, M10 x 150lg Hex Hd, sst, pass 2
13 Nut, M10, sst, pass 10
14 Clamp Bracket 1
15 M10x140lg Eye Bolt, sst, pass 2
www.commscope.com\andrew
7663461
Bulletin
Version RevStatus
Visit our Web site at www.commscope.com\andrew or contact your local Andrew Solutions representative for more information.
assemby, installation & adjustment.
1 of 10
page
Installation Instructions
BRE
01
Andrew Solutions
Valuline™ 2ft 80GHz Antenna mount
© 2008 CommScope, Inc. All rights reserved.
Andrew Solutions is a trademark of CommScope. All trademarks identified by ® or ™ are registered trademarks or trade-
marks, respectively, of CommScope. This document is for planning purposes only and is not intended to modify or supplement
Other Europe: +44 592 782 612
U.K.: 0800 250055
or 1-888-235-5732
U.S.A., Canada, Mexico: 1-800-255-1479
Customer Service 24 hours
any specifications or warranties relating to Andrew Solutions products or services.
Notice: Andrew disclaims any liability or responsibility for the results of improper or unsafe installation, inspection, maintenance, or removal practices.
Aviso: Andrews no acepta ninguna obligacion ni responsabilidad como resultado de practicas incorrectas o peligrosas de instalacion, inspecci6n, mantenimiento o retire.
Avis : Andrew decline toute responsabilite pour les consequences de procedures d'installation, d'inspection, d'entretien ou de retrait incorrectes ou dangereuses.
Hinweis: Andrew lehnt jede Haftung Oder Verantwortung fur Schaden ab, die aufgrund unsachgemaBer Installation, Uberprufung, Wartung Oder Demontage auftreten.
Atencao: A Andrew abdica do direito de toda responsabilidade pelos resultados de praticas inadequadas e sem seguranca de instalacao, inspecao, manutengao ou remocao.
Awertenza: Andrew declina eventual! responsabilita denvanti dell'esecuzione di procedure di installazione, ispezione, manutenzione e smontaggio improprie o poco sicure.