CommScope MST-4 Installation guide

MST-4

INSTALLATION INSTRUCTION

MST-4

The Multiport Service Terminal (MST) is supplied with a length of feeder

cable and incorporates hardened connector technology that is designed

to withstand the rugged outside plant environment. These hardened

connectors are factory-terminated and environmentally sealed for use in

optical drop cable deployments.

1.1 Open the terminal with a ﬂat screw driver.

Turn 90° counterclockwise.

1 Wall mounting

1.2 Mount the terminal to the wall with the 3 screws in the kit.

2.3 Connect the 2 dust caps from terminal port and hardened

connector to keep the dust caps clean for future use.

2.2 Orientation of the connector: white dot facing upwards.

2.1 Unscrew the dust caps off both, the connector and the adapter, and

install the hardened connector (hand tighten).

2 Customer connection

Always clean the connector before inserting!

General

TC-1248-IP

Rev A, Apr 2017

www.commscope.com

MST-4

INSTALLATION INSTRUCTION

3 Close and lock the terminal.

MST-4

All trademarks identiﬁed by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc.

This document is for planning purposes only and is not intended to modify or supplement any speciﬁcations or warranties relating to

CommScope products or services.

This product is covered by one or more U.S. patents or their foreign equivalents. For patents, see:

www.commscope.com/ProductPatent/ProductPatent.aspx.

To ﬁnd out more about CommScope® products, visit us on the

web at www.commscope.com

For technical assistance, customer service, or to report any

missing/damaged parts, visit us at:

http://www.commscope.com/SupportCenter